Connecting The Conductor / Pro To A Dsp / Dsp Amplifier - Helix Conductor Bedienungsanleitung

2. Installation instructions
2.3 Connecting the CONDUCTOR / PRO to a DSP / DSP amplifier
1. Connect the CONDUCTOR connection cable to the DSP / DSP amplifier
1.1 DSP / DSP amplifier with SCP (Smart Control Port)
Insert the SCP connector of the CONDUCTOR connection cable into the multifunction port (SCP) of the DSP /
DSP amplifier.
Note: If your CONDUCTOR is not equipped with a SCP connector ("for Control Input" version), an SCP-to-Control
Input adaptor (art. no. M141313) is optionally available from your authorized dealer.
1.2 DSP / DSP amplifier with Control Input (only CONDUCTOR for Control Input)
If your DSP device is still equipped with a Control Input, insert the round connector of the CONDUCTOR con-
nection cable into the multifunction port (Control Input) of the DSP / DSP amplifier.
Turn your sound system on and then start the DSP PC-Tool software. You can find the software at
www.audiotec-fischer.de/dsp-pc-tool (compatible from DSP PC-Tool software version 5).
Power is supplied to the CONDUCTOR / PRO via the DSP and it is switched on automatically.
2. Open the „Remote Control" menu (1) in the DSP PC-Tool. There (2), select the CONDUCTOR / PRO to open its
configuration menu.
3. You can now change other CONDUCTOR / PRO settings. More information on the configuration is provided on
page 35 et seq., "Configuration in the DSP PC-Tool software".
4. To complete the process, save the settings and the activation of the CONDUCTOR / PRO in the DSP / DSP ampli-
fier by clicking on the "Save" button in the DSP PC-Tool.
28
CONTROL USB SCP
GND ISO 200Ω STATUS
2
LINE OUTPUT
USB-AUDIO
1