Configuration In The Dsp Pc-Tool Software; General Configuration; Main Menu; Automatic Switch Back To Main Menu - Helix Conductor Bedienungsanleitung

4. Configuration in the DSP PC-Tool software
Overview of the configuration menu
The configuration menu is located in the "Remote Control" menu of the DSP PC-Tool software. However, the menu is
only visible if you have selected the CONDUCTOR / PRO as described on page 28.
All CONDUCTOR settings are changed in the configuration menu.
The menu is divided into the "General Configuration", "Volume Control Configuration" and "Status" area.
4.1 General Configuration
The "General Configuration" area is used for all the basic Menu Configuration and LED display (LED Configuration)
settings.
4.1.1 Main menu
This is where the CONDUCTOR's start menu, which is accessed immediately after the DSP is switched on, is
defined.
Volume Control, Signal Input selection, Sound Setup selection and Bluetooth Playback Control menu are avail-
able for selection.
4.1.2 Automatic switch back to main menu
If the function is enabled, the CONDUCTOR switches back to the set "Main menu" after around 5 seconds, if
another menu was previously selected. If the function is disabled, the currently selected menu remains selected
until it is manually changed by briefly pressing the button.
4.1.3 Menu activation
This lets you enable and disable the volume controls as well as other menus. If a menu is disabled, it cannot be
selected by the CONDUCTOR.
en
35