Loading And Reloading The Tool - Avdel 7536 Betriebsanleitung

P u t t i n g i n t o S e r v i c e

Loading and Reloading the Tool

The procedure for loading the tool and for fitting the nose equipment to the tool is integral.
When ordering a complete tool or system you will normally be supplied with all the nose equipment required for the fastener to be
placed.
If you have been supplied with a nose jaw, mandrels and mandrel follower springs proceed with loading the tool and fitting the nose
equipment as shown below.
Loading the Tool
•
Connect the air supply to the tool.
•
Open Tail Jaws 32 which grip the mandrel, by switching off the tail jaw switch (items 18 and 19).
•
Screw selected nose jaws onto Barrel 44 of the tool.
•*
Insert a mandrel into the tail end of the fasteners through the paper pod.
•
Slide the mandrel follower spring onto the mandrel ensuring correct orientation.
•
Gripping the tail end of the mandrel, tear off the paper pod from around the fasteners.
•
Open the nose jaws either by rotating the outer ring on Cam operated jaws or by pushing outwards on the jaw ends, as illustrated
below left.
•
Insert the previously assembled mandrel, mandrel follower spring and fasteners into the nose jaws until the first fastener to be
placed is protruding from the nose jaw.
•
Close the nose jaws and adjust so that the first fastener protrudes by 1.5mm - 3mm (
below right.
•
Close the Tail Jaws 32 to ensure the mandrel is gripped, by switching on the tail jaw switch (items 18 and 19).
Re-loading the Tool
•
Open Tail Jaws 32 of tool, by switching off the tail jaws (items 18 and 19).
•
Open the nose jaws and pull the empty mandrel and mandrel follower spring out of the tool.
•
Reload the tool by following the above instructions, starting at stage
Item numbers in bold refer to the general assembly and parts list for the 07536-02200 Tool on pages 16-17.
IMPORTANT
1
•*
.
1
/ " to / "), as shown in the illustration
16 8
1.5mm - 3mm
1 /16 1 /8
( " - ")
9