Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To loosen the mixing paddle (7), use an open-end wrench SW 24. Hold
with an open-end wrench SW 27 on the work spindle.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel.
After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points always have to be
observed:
Keep the machine and the controls clean and functional.
To clean the mixing tools, rotate the motor unit by 180 degrees (see
page 7 - Assembly of the device). Please pay attention that no water
can get into the motor during cleaning.
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
Use only the original mixing bucket from Eibenstock as replacement for
a worn mixing bucket. Correct function is guaranteed only with this
mixing bucket.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in
a sturdy packing. The packing as well as the tool and its accessories are
made of recyclable materials which makes it possible to remove
environmental friendly und differentiated because of available collection
facilities.
Only for EU countries
Do not dispose of electric tools together with household
waste material!
In observance of the European Directive 2012/19/EU on
waste electrical and electronic equipment and its
implementation in accordance with national law, electric
tools that have reached the end of their life must be
collected separately and returned to an environmentally
compatible recycling facility.
22
Werbung
