AMiO 04579 Benutzerhandbuch

EN
EN - USER MANUAL
LED FLEXIBLE COB STRIP LIGHT
Bright LED lights are ideal for interior lighting, for example in cars,
caravans and boats. The LED light strip is made of flexible and
waterproof material. You can cut the tape as instructed. With the
3M sticker, you can easily attach the tape where you want it.
TECHNICAL SPECIFICATION
• Working Voltage: DC 12 V
• LED Color: RGB
• Color Options: 15
• LED Strip Length: 30 cm x2 pcs
• Cable Length: approx. 2x 90 cm
• Service Life: about 20000 h
INSTALLATION INSTRUCTIONS
Before installation, test the product and plan the wiring route
to ensure it won't interfere with vehicle operations, drag on the
ground, or snag on objects.
1. Select your desired location inside the vehicle.
2. Clean the surface thoroughly with isopropyl alcohol (not inc-
luded).
3. Peel back the 3MTm backer at one end, then carefully apply the
strip to the cleaned surface, gradually removing the remaining
backer as you go
4. 12 V Power Adapter:
a. Connect the power adapter to any 12 V power socket .
b. Power on/off the strip using the switch on the adapter.
TRIMMING THE STRIP
Make a vertical cut through the copper pads.
LED strip may be cut for better fit, but only at locations shown in.
IN-LINE CONTROLLER
1.Power Button
Press to toggle the LED strips on or off.The light will resume in
the same mode you last used when you turn it back on.
2. Multi-Color Control Button
Press to switch between the 15 available colors.
#1 WHITE #6 BERTA BLUE
#2 AMBER #7 HELIOTROPE
#3 YELLOW #8 PURPLE
#4 LIGHT YELLOW
#5 AQUA BLUE
3.Individual Color Control Button
Select your preferred color for the LED strips.
4.Mode Control Button
Press
#1 GLOW
#4 FADE
#7 SCAN RIGHT
#10 BOUNCE
5. Brightness Control Button
Press
four LED strips are connected and set to any of the four SCAN
modes, they will display a complete cycle of scanning effects. You
can utilize the following buttons to adjust the scanning pattern:
6. Extend Scan Cycle Button
Press
will create a smooth and seamless flow of light.
7. Shorten Scan Cycle Button
Press
cycles will run at the same time to create a layered effect.
NOTE: You can only adjust the scan cycle length when in one of the
four SCAN modes.
#11 GREEN
#12 BLUE
#13 ORCHID
#9 PINK
#10 RED
to switch between the 10 available light modes.
#2 BLINK
#5 SCAN
#8 SCAN RIDER
to switch between the 5 available brightness levels. When
to extend the scan cycle length.Fewer, longer scan cycles
to reduce the scan cycle length.Multiple shorter scan
ENVIRONMENTAL PROTECTION
This symbol indicates that this product should not be
disposed of with unsorted municipal waste. Electronic
P/N: 04579
#14 SKY BLUE
#15 GOLDEN
#3 STROBE
#6 SCAN LEFT
#9 RAINBOW
1