AMiO DBHL-0350 Benutzerhandbuch

EN
EN - USER MANUAL
Multi-Function Rechargeable Headlamp DBHL-0350
CONTROLS:
XPG Mode Switch
• Press the XPG button to cycle through the available modes:
Low -> Medium -> High -> Off.
• Press and hold to activate Super Brightness Mode.
SMD Mode Switch
• Press the SMD button to switch between modes: White SMD
-> Red SMD -> Red SMD Strobe -> Off.
Note: If you press the switch more than 8 seconds after the last
operation, the headlamp will turn off directly.
PRODUCT OVERVIEW:
• Equipped with a Super Brightness Mode, delivering up to
1200 lumens.
• Features long-lasting SMD working mode with a runtime of
over 55 hours.
• The lamp can be tilted up to 45° downward for optimal
illumination of the path ahead.
SAFETY WARNINGS:
• This device contains a rechargeable lithium battery. Always
use the recommended charging methods. Improper
charging may result in battery damage, short circuits, fire,
or explosion.
• Fully charge the battery before storing the device for
extended periods to prevent over-discharge and potential
damage caused by self-discharge.
• Do not shine the light directly into anyone's eyes. The
intense brightness may cause temporary blurred vision,
especially in children.
• Ensure the charging port cover is closed securely when not
charging.
• This device is not a toy. Keep out of reach of children.
SPECIFICATIONS:
• Material: ABS + TPR
• Light Source: XPG + 10 SMD LEDs (6 White, 4 Red)
• Battery: 1 × 1800 mAh Li-ion Battery (included)
• Dimensions: 78 × 50 × 44 mm (L × W × H)
• Weight: 121 g (with battery)
• Maximum Brightness: 1200 lumens
• Charging Time: 3 hours
• Operating Time: 5 to 5.5 hours
BATTERY REMOVAL INSTRUCTIONS:
1. Open the Back Cover: Unclip the buckle located on the rear
side of the headlamp.
2. Loosen the Battery: Using a flat tool (e.g., a flathead scre-
wdriver), gently pry the battery away from the double-sided
tape. Proceed slowly to avoid damaging the battery or the
printed circuit board (PCB).
3. Remove the Battery: Carefully grip the battery connector
and pull the battery out gradually.
DECLARATION OF CONFORMITY
DECLARATION OF CONFORMITY AVAILABLE AT THE
REGISTERED OFFICE OF AMIO SP z o.o. ul. Handlowa 3,
41 - 807 Zabrze
WASTE MANAGEMENT AND RECYCLING
This symbol indicates that this product should not be
disposed of with unsorted municipal waste. Electronic
equipment should not be disposed of with household waste.
According to the European Directive 2002/96/EC on waste
electrical and electronic equipment and its incorporation into
national law, waste electrical and electronic equipment must
be collected separately and recycled. You can also take your
used equipment to an electronic waste collection point, which
disposes of the equipment in accordance with the National
Recycling and Waste Act. It also helps to avoid potential
damage to the environment and human health and helps to
conserve natural resources.
INSTRUCTIONS FOR OPERATION AND SAFETY
OF BATTERIES IN AMIO PRODUCTS
PRECAUTIONS
• Do not throw into fire — batteries may explode or leak.
• Do not disassemble or crush — this can cause leakage of
chemicals that are harmful to health.
• Do not recharge disposable batteries — this can lead to
overheating, leakage or explosion.
• Avoid short-circuiting — do not connect the battery
terminals with a conductor, such as a coin or key. This can
cause overheating and damage to the battery.
• Keep away from children and pets — swallowing batteries
can be dangerous and requires immediate medical
attention.
USE
• Use only as intended — make sure the battery
is compatible with the device.
• Always insert batteries correctly — pay attention to the
poles (+ and -).
P/N: 04668
1