AMiO DBHL-0349 Benutzerhandbuch

EN
EN - USER MANUAL
Multi-Function Rechargeable Sensor Headlamp
DBHL-0349
CONTROLS:
Power Switch
• Press to cycle through three lighting modes: COB White,
COB Warm, and COB White + Warm.
• Press and hold to activate the dimmer function. The light will
flash once, and the brightness will adjust to the maximum
or minimum level.
Sensor Switch
• Press to activate sensor mode.
• When the sensor switch is pressed again within 8 seconds
after releasing it, the light will turn off.
FEATURES:
Sensor Mode:
• Easily turn the light on or off by waving your hand in front of
the motion sensor, perfect for situations when your hands
are occupied or dirty.
Adjustable Brightness:
• The dimmer function allows you to customize the light
intensity to your preference.
Adjustable Angle:
• The headlamp tilts up and down up to 45°, allowing you
to direct the beam downward to illuminate your path
effectively.
SAFETY WARNINGS:
• This device contains a rechargeable lithium battery. Always
use the recommended charging methods. Improper
charging may result in battery damage, short circuits, fire,
or explosion.
• Fully charge the battery before storing the device for
extended periods to prevent over-discharge and potential
damage caused by self-discharge.
• Do not shine the light directly into anyone's eyes. The
intense brightness may cause temporary blurred vision,
especially in children.
• Ensure the charging port cover is closed securely when not
charging.
• This device is not a toy. Keep out of reach of children.
SPECIFICATIONS:
• Material: ABS + TPR
• Lamp Type: White COB + Warm COB
• Battery: 1 × 1800 mAh Li-ion (included)
• Dimensions: 78 mm (L) × 50 mm (W) × 44 mm (H)
• Weight: 115 g (with battery)
• Brightness: 600 lumens
• Charging Time: Approximately 3 hours
• Operating Time: 5 to 8 hours
BATTERY REMOVAL INSTRUCTIONS:
1. Open the buckle located on the back of the headlamp.
2. Using a flat tool (e.g., flathead screwdriver), gently pry the
battery upward to detach it from the double-sided tape.
Take care to proceed slowly to avoid damaging the battery
or circuit board.
3. Grip the battery connector and carefully pull the battery out.
DECLARATION OF CONFORMITY
DECLARATION OF CONFORMITY AVAILABLE AT THE
REGISTERED OFFICE OF AMIO SP z o.o. ul. Handlowa 3,
41 - 807 Zabrze
WASTE MANAGEMENT AND RECYCLING
This symbol indicates that this product should not be
disposed of with unsorted municipal waste. Electronic
equipment should not be disposed of with household waste.
According to the European Directive 2002/96/EC on waste
electrical and electronic equipment and its incorporation into
national law, waste electrical and electronic equipment must
be collected separately and recycled. You can also take your
used equipment to an electronic waste collection point, which
disposes of the equipment in accordance with the National
Recycling and Waste Act. It also helps to avoid potential
damage to the environment and human health and helps to
conserve natural resources.
INSTRUCTIONS FOR OPERATION AND SAFETY
OF BATTERIES IN AMIO PRODUCTS
PRECAUTIONS
• Do not throw into fire — batteries may explode or leak.
• Do not disassemble or crush — this can cause leakage of
chemicals that are harmful to health.
• Do not recharge disposable batteries — this can lead to
overheating, leakage or explosion.
• Avoid short-circuiting — do not connect the battery
terminals with a conductor, such as a coin or key. This can
cause overheating and damage to the battery.
• Keep away from children and pets — swallowing batteries
can be dangerous and requires immediate medical
attention.
P/N: 04666
1