Introduction; Voltage Converter; Intended Use - AEG ST 500 Bedienungshinweise

Introduction

In this operating manual / this device the following pictogram's are used:
Read operating manual!
Observe warning- and safety
guidelines!
Danger to life and danger of
accident for children!

Voltage converter

Introduction
Make yourself familiar with all functions
before first start-up of the equipment
and gain inform you about correct
handling the device. Read for this the following
operating manual carefully. Store this manual
carefully. Pass on all documents also when passing
on the device to third parties.

Intended use

The voltage converter is meant for the conversion
of DC current with a voltage of 12 V into AC with
a voltage of 230 V and a frequency of 50 Hz and /
or 5 V DC and amperage of 500 mA. Always check
for a continuous maximum output capacity
(see also chapter "Error tracing". It is exclusively
certified for the private use. All other use or change
to the device is considered as not intended and
bears substantial dangers. The manufacturer does
not take over any liability for damages arising
from unintended use.
This device can be used for the following kind of
external electrical appliances when connected to
a 12 V power supply with at least 1 A:
- Common electrical appliances such as laptop,
table calculator, TV, MP3-player, PDA or bat-
tery charger for mobile phones, computer.
- 97115 (Model ST 500) = Total capacity< 500 W
16 GB
Indoor use only
Dispose the packaging environmen-
tally friendly!
- 97116 (Model ST 800) =
Total capacity< 800 W
- 97117 (Model ST 1200) =
Total capacity< 1200 W
- 97120 (Model SW 600) =
Total capacity< 600 W
- 97121 (Model SW 1000) =
Total capacity< 1000 W
- 97122 (Model SW 1500) =
Total capacity< 1500 W
Not permitted is the use of the device under
the following circumstances and with the fol-
lowing kind of external electrical appliances:
- Connection to a power supply with a
voltage of 6, 24 or 230 V
- External appliances, which exceed the
maximum capacity of the voltage converter.
- 97115 (Model ST 500) =
Total capacity> 500 W
- 97116 (Model ST 800) =
Total capacity> 800 W
- 97117 (Model ST 1200) =
Total capacity> 1200 W
- 97120 (Model SW 600) =
Total capacity> 600 W
- 97121 (Model SW 1000) =
Total capacity> 1000 W
- 97122 (Model SW 1500) =
Total capacity> 1500 W
Use of heat producing appliances
Take utmost care of the capacity indicated by
the manufacturer when using heat producing
appliances. Ensure that the required capacity
does not exceed the maximum output capacity
of the voltage converter.