Maxwell Digital Multimeters 25629 Benutzerhandbuch Seite 5

dc voltage measurement
Set the function switch to the V≅Hz position.
•
The device will automatically set to DC voltage
measurement.
Connect the red measuring wire to the
•
V•Ω•CAP• TEMP • HZ connector and the black
one to the COM connector.
Connect the end of the measuring wires to the
•
measured circuit.
Read the display.
•
true rmS ac voltage measurement
Set the function switch to the V≅Hz position.
•
Press the MODE buttonto select the AC Volt
•
range.
Connect the red measuring wire to the
•
V•Ω•CAP• TEMP • HZ connector and the black
one to the COM connector.
Connect the end of the measuring wires to the
•
measured circuit. Read the display.
note: press the peak button to hold the maximum and
minimum measured values in the ac current range.
resistance measurement
Set the function switch to the
•
Connect the red measuring wire to the
•
V•Ω•CAP• TEMP • HZ connector and the black
one to the COM connector.
Touch the end of the wires to the outputs of
•
the measured device
Read the display
•
Warning! Before starting the measurement
always make sure that the measured circuit is
not under voltage!
capacity measurement
Set the function switch to the CAP position.
•
Connect the red measuring wire to the
•
V•Ω•CAP• TEMP • HZ connector and the black
one to the COM connector.
Touch the end of the wires to the outputs of
•
the measured device
Read the display
•
note:
the device only does automatic capacity measurement.
•
Warning! to avoid damage to the device, always make
•
sure that the measured device is not under voltage and
all capacitors have been discharged.
Warning! discharge high capacity capacitors with
•
a proper resistor and make sure that it is not under
voltage with a dc voltage measurement.
frequency measurement
Set the function switch to the V≅Hz position.
•
Press and hold the MODE button for 3 seconds
•
to select Frequency measurement.
Connect the red measuring wire to the
•
V•Ω•CAP• TEMP • HZ connector and the black
one to the COM connector.
Touch the end of the wires to the outputs of
•
the measured device
note: the device only performs automatic frequency
measurement
temperature measurement
Set the function switch to the TEMP position.
•
The device will automatically switch to °C
measurement.
Connect the white temperature adapter to the
•
V • Ω • CAP • TEMP • HZ and COM connectors.
•
Make sure that the „-" adapter cable is
connected to the COM connector and the
„+" is connected to the V • Ω • CAP • TEMP • HZ
connector.
Connect the K-type cable to the adapter of the
•
device and measure the temperature at the
desired area.
position.
Read the result from the screen.
•
To switch between measuring modes (°C/°F)
•
use the MODE button.
note: the device will show an error when you try to set it
to automatic measuring range.
diode test
Set the function switch to the
•
Press the MODE button to select Diode
•
measurement.
Connect the red measuring wire to the
•
V•Ω•CAP• TEMP • HZ connector and the black
one to the COM connector.
Touch the end of the wires to the outputs of
•
the measured device. Read the display
note: if you switch the connections of the cables through
the diode, the display will show ol. normal values are
between 0,4 - 0,9v.
continuity test
Set the function switch to
•
Press the MODE button for selecting continuity
•
measurement.
Connect the red measuring wire to the
•
V•Ω•CAP• TEMP • HZ connector and the black
one to the COM connector.
EN
User Manual
position.
position.