Stadler Form Albert Gebrauchsanweisung Seite 12

• Do not immerse the dehumidifier into water or any other liquids and do
not pour water or any other liquids onto the appliance or into the air intake
and air outflow vents.
• Clean the dehumidifier regularly, following the cleaning instructions.
• Always transport the dehumidifier in an upright position. Before using
the dehumidifier for the first time, leave it standing in an upright position
for 24 hours. Always stand the dehumidifier in an upright position imme-
diately after transporting the appliance, and wait for at least 60 minutes
before switching it back on. The water tank must be emptied every time
before transport.
• The dehumidifier must always be operated according to this instruction
manual. Non-observance of these instructions can lead to injuries, a fire,
electric shock or faults in the appliance.
• The dehumidifier is designed for private use indoors and is not intended
for commercial use.
• Do not use the dehumidifier if it is faulty or could show signs of damage,
or if it is not functioning correctly. Disconnect the plug from the power
socket.
• The appliance shall be installed in accordance with national wiring regu-
lations.
Setup / operation
1. Place Albert on a flat surface in the desired area. Plug the power cable
(16) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. You can select the speed of the fan in the dehumidifier by pushing
the speed level selector (5). There are 3 speed levels. If the speed is
higher, the dehumidifying performance also increases.
4. With the hygrostat (4) the desired humidity level can be set. Press on
the knob hygrostat (4) and change to desired humidity level with the
rotary control (10). Humidity levels between 30 and 80% or continuous
running (CO in display) can be selected. A humidity level not higher
than 60% is suggested in general. If the dehumidifier reached the
selected humidity it will turn off and after that check the humidity
level in constant intervals by turning on the fan for a short time.
5. With the timer you can select precisely when Albert should be run-
ning. The timer can be activated by pressing the knob timer on/off
(6) and the LED will be lit. If you press the knob again the timer will
not be active and the LED will be off. To set the timer follow these
instructions:
6. Set the time: Press set (7) for 5 seconds and the symbol for hour is
shown blinking in the display, in addition the hours are blinking. Now
you can choose the correct hour with the rotary control (10). If the
hours are correct, press set (7) again and the minutes can be adjusted
the same way. To finish press set (7) again.
7. Set the timer: Press set (7) shortly and now you can set the time when
the unit should turn on (timer on) and the time when the unit should
stop (timer off), setting is the same as for the time above. If the timer
is activated (blue LED is on), the dehumidifier will start and stop every
day at the set time (this is ideal for example to use the cheaper power
tarifs at night).