Grundig R45 a Bedienungsanleitung Seite 11

o
On/Off switch
o
Loudspeaker switches
MPX switch (MPX multiplex stereo
reception)
O
Linear/Contour switch (loudness
control)
Noise filter
o
Monitor switch
8
Keys for FM preset programmes
Programme keys
u = FM reception (for FM tuning
with knob O on main scale
M Medium wave reception
TA = Playback of records (with
magnetic pick-up)
TBI Tape/Cassette playback via
socket TB I
TB2=
Tape/Cassette playback via
socket TB 2
MIX programme level control for Radio,
Tape or Record
Function mode selector for microphone
and/or mixing operation
o
Microphone level control
Switch for built-in transformer
symmetrical microphones
Microphone input
Stereo headphone sockets
Bass control
Stereo balance control
Tone selector switch for 5 preferred
frequencies (160 Hz; 400 Hz; I kHz;
2.5 kHz; 6.3 kHz)
Control for emphasizing or attenuating
the selected frequency
Volume control
Treble control
Muting switch for muted tuning on FM
Frequency meter for FM preset
programmes
FM "Tunoscope"
Tuning meter/FM field strength indicator
0 AFC switch on FM
O
Indicator for FM reception on main scale
FM stereo indicator
Multipath indicator
Medium wave indicator
O
Tuning knob
O Aerial sockets
Y AM aerial (for MW reception)
earth
nr FM dipole (300 Q)
Connecting socket for FM aerial rotor
(special accessory)
Connecting socket for record player
with magnetic
Connecting socket
recorder
Connecting socket for a second
tape/cassette
player with crystal or ceramic pick-up.
Monitoring socket
Line output
Low impedance/high
connecting for example professional
tape mafflines,
consoles etc. Together with the Monitor
socket also for
unit or reverberation
Loudspeaker
(R = right-hand
channel).
Loudspeaker
Mains voltage indication
changed by a technician
set to another voltage range).
for
Mains Connection
This set has been designed
on AC and is pre-set
operation on an other
voltage setting should be changed by an
experienced technician.
Additional Information
Great Britain
The set is factory-preset
mains supply of 240 V AC. Your dealer Will
install your set
your local electricity
no further adjustments
We recommend
used, fitted with
lead should be connected
(marked L or red or
lead must be connected
(marked N or black or blue). On no ac-
count should either
nected to the earth pin (marked E or green/
yellow). If other
Dlease ensure that
a 5 amp fuse.
We recommend
ed from the mains
periods.
Aerials
with a simple indoor aerial (ie: the
GRUNDIG
shown
signal is required for satisfactory
stereo
pick-up
important
for tape/cassette
when attempting to listen to stereo broad-
casts.
recorder or a record (preferably on the roof), will improve the
strength of the received signal and the
extra expense
improved listening pleasure afforded to
the listener.
level output for
essential for the best possible signal to
noise ratio performance
amplifiers, lighting
stereo
At the rear of the unit you Will find sockets
connection of a mixer
(posn. O) for fitting both VHF/FM and AM
device.
aerials
sockets — group I
The
channel. L left-hand
VHF/FM
socket will also improve reception on the
sockets — group II MW band. The Y socket is intended for
use on the MW band only and is a high
(must be
impedance
after having
aerial system.
type is fitted, the wire link between
FM and
removed
to be operated
upset the balance of the VHF dipole.
for 220 V. For
Socket
mains voltage, the
is provided
connecting the special VHF aerial rotator
accessory.
be able to advice you further on your
for sets sold In
aerial
assistance should be sought in cases of
to operate from a
difficulty.
for you and ensure that
supply is suitable and
should be necessary.
that a 13 amp 3-pin Plug be
a 3 amp fuse. The brown
to the live pin
brown) and the blue
to the neutral pin
of the wires be con-
mains plugs are used
they are protected with
that the set be disconnect-
when not in use for long
In areas of high signal strength it is
possible to obtain satisfactory
indoor aerial). Research
that about ten times the aerial
reception than for mono. tt is very
that this fact is borne
The installation of an efficient
FM dipole, mounted as high as possible
will be repaid in the
A high signal strength
and for good
separation.
and earth.
socket is provided
and connecting an aerial
socket suitable for a long wire
If an AM aerial of any
AM aerial sockets must
so that the AM aerial
is for earth connection.
at the rear of the receiver
Your local dealer will of course
requirement and his advise
reception
has
VHF/FM
in mind
VHF/
is
for use on
to this
the
be
will not
for
and
II