Siemens REV24RF Installationsaleitung Seite 8

Press or until the language you require appears.
Press or move the slider to confirm the selected language
(also refer to Fig. G)
3 Mounting the RCR10/868 temporarily
•
If possible, mount the receiver temporarily (e.g. using double-
sided adhesive tape), thus allowing you to find the location
with the best reception conditions
•
Wire completely the RCR10/868.
For steps to be followed, refer to Figs. H through M (close the
front also)
4 RCR10/868 and REV24RF..
•
The units are supplied interconnected
•
For manual connection, refer to operating instructions
5 Mounting and setting up the
REV24RF..
•
Refer to "Mounting instructions REV24RF.. and RCR10/868"
•
Mount or set up the REV24RF.. at your preferred location:
Remove the unit from its baseplate; for procedure, refer to Fig.
A
- For wall mounting, refer to Figs. B, C and D
- For setting up, refer to Fig. E
Configuration and function check REV24RF..
2 Configuration
1.2 DIP switches
ON / OFF
Sensor calibration on
See
1.1.1
Sensor calibration off
Setpoint limitation
16...35 °C
1.1.2
Setpoint limitation
3...35 °C
Temperature display °F
1.1.3
Temperature display °C
PID self-learning
PID 6
1.1.4
PID12
2-Point
1.1.9
When changing one or several DIP switch positions, a DIP switch reset must be made by pressing the DIP switch reset
button (also refer to Fig. 8). Otherwise, the previous settings will be maintained!
8/29
1 2 3 4
DIP switch reset
Note: The factory setting of all DIP switches is
13.12.2007
6 Finding the best place for reception
a) Switch on the RCR10/868
b) Set up the REV24RF.. at your preferred location.
Test the radio link by pressing the TEST button at the rear of
the controller (refer to Fig. N1)
c) The display of the REV24RF.. shows the quality of the radio
link. The longer the bar below the numbers 0...9, the better the
quality of the radio link. If the bar only appears below number
0, there is no secure radio link (refer to operating instructions)
Insufficient Sufficient
d) On the receiver, LED_1 indicates the quality of the radio link
(refer to Fig. N2):
Red = insufficient or no connection
Orange = good
Green = very good
e) If the quality of the radio link is insufficient, reduce the distance
between controller and receiver.
Then, repeat the test
7 Mounting the RCR10/868 in its final
place
a) Switch power off
b) Mark the place where the RCR10/868 is located
c) If necessary, remove wiring
d) Mount the receiver at the place previously identified (refer to
Figs. H through M), complete wiring and close the housing
e) Switch power on
5 6 7 8 9
ON
1 2 3 4 5 6 7 8 9
OFF
Good Very good
10
Periodic pump run on
Periodic pump run off
Optimum start control:
1 h/°C
Optimum start control:
¼ h/°C
Optimum start control:
½ h/°C
Optimum start control:
Off
(Cooling on)
(Heating on)
Quartz
Radio clock
CE1G2206xx
See
1.1.5
1.1.6
1.1.7
1.1.8
1.1.9