Siemens REV24RF Installationsaleitung Seite 10

2 Accessing the expert level
Move the selector slider to the RUN position and press simultaneously
seconds, press simultaneously
access the expert level for making the settings on that level.
Starting with code 00, the display shows the choice of languages. Navigation on the expert level is made possible with
the settings by pressing .
The expert level is quit by pressing the operating mode selection button
Function block
Basic settings
LCD settings
Clock settings
Note 1:
If the radio clock is not active or not present, this setting has no impact.
With the radio clock active, the time signal received from Frankfurt is shifted by the value set under code 30 (time zone).
Note 2:
If the radio clock is not active or not present, the time change always takes place at 02:00 on the Sunday before the set date.
With the radio clock active, the time change is shifted by the value set under code 30 (time zone).
Note 3:
If the radio clock is not active or not present, the time change always takes place at 03:00 on the Sunday before the set date.
With the radio clock active, the time change is shifted by the value set under code 30 (time zone).
3 Function check
g)
Check the display. If there is no display, check the batteries
h) "Continuously Comfort mode"
displayed
i) REV.. in heating mode: Set the temperature setpoint to a level
above the displayed room temperature (see operating
instructions).
REV.. in cooling mode: Set the temperature setpoint to a level
below the displayed room temperature (see operating
instructions).
j)
The relay and thus the actuating device must respond within
▲
appears on the display. If not:
1 minute. Symbol
•
Check actuating device and wiring
•
In heating mode, the room temperature is possibly higher
than the adjusted temperature setpoint, in cooling mode
possibly lower
k) Set temperature setpoint of "Continuously Comfort mode"
the required level
l) Select the required operating mode
10/29
and for 3 seconds, release
Code Name
00 Language
01 Sensor calibration
02 Switching differential
10 Illumination time
11 Background brightness
12 Contrast
Time zone
Deviation from time signal
30 received from Frankfurt
(Central European Time CET)
(refer to Note 1)
Start of summer time
31
(refer to Note 2)
End of summer time
32
(refer to Note 3)
, read the temperature
and for 3 seconds, then release the buttons and, within 3
and keep depressed for another 3 seconds. This enables you to
on display (also refer to Fig. G).
Code list
.
Factory setting
English
off
0.5 °C
10 seconds
0
0
0 hours
March 31 (31-03)
October 31 (31-10)
4 Reset
User-defined settings:
Press simultaneously
All temperature and time settings of the slider positions are reset to
their default values (refer to section "Factory settings" in the
operating instructions). The settings made on the expert level will
remain unchanged.
The clock starts at 12:00, the date on 01-01-08
(01 - January - 2008). During the reset time, all sectors of the
display are illuminated and can thus be checked.
All user-defined settings plus those made on the expert level:
Press simultaneously the DIP switch reset button,
for 5 seconds:
After this reset, all factory settings will be reloaded. This applies to
both the slider settings and the settings made on the expert level.
Notes
to
•
The controller is classified as a device of software class A and
designed for use in environments with normal degree of
pollution
•
REV24RF/SET is a set of units consisting of electronic room
temperature controller with 7-day time switch, RF transmitter
(REV24RF..) and RF receiver (RCR10/868)
13.12.2007
and . Confirm
Your setting
, and for 3 seconds:
CE1G2206xx
and