Maintenance And Cleaning - tepro Fairfax Bedienungsanleitung

t
Maintenance and
Cleaning
Your smoker is made from high-quality
materials� To clean and maintain the
surfaces, please heed the following
instructions:
Danger Risk of burning!
Let the smoker cool down
completely before cleaning it�
– Only tip out the ash when the fuel has
completely burned out�
Danger Health risk!
Do not use any decolourants or
thinners to remove stains� These
are harmful to health and must
not come into contact with food�
Attention Risk of damage!
Do not use any strong or
grinding solvents or abrasive
pads, since these can attack
the surfaces and leave behind
scrape marks�
• Let the fuel burn out completely after
grilling� This eases the cleaning effort
by burning away excess fat and grill
residues�
• Remove the cold ash and clean the
smoker regularly, ideally after each use�
• Take out the grates and hooks and
clean them thoroughly with soapy
water� Then dry off the parts thoroughly�
• After cleaning, apply a thin layer of
vegetable cooking oil to the grates and
hooks�
• Remove loose deposits on the grill
and smoking chambers using a damp
sponge�
• Use a soft, clean cloth for drying� Do
not scratch the surfaces when wiping
them dry�
28
P150364_TEPRO_FAIRFAX_1104N_SMOKER_20151118.indb 28
• Clean the internal and external surfaces
generally with warm soapy water�
• Regularly tighten all screws before
each use, in order to ensure the smoker
is standing firmly every time you use it�
• Protect your
continuous weather influences� Since
it is manufactured from steel it will
eventually rust� Clean possible rust
spots and repair them with oven paint�
It is very important that you remove
the ash from the grill chamber before
moisture combines with the cold
ash� Ash contains salt and affects
the inside of the ash collection tray
when damp� In this way, the grill
chamber can be damaged by rust
over the years�
• IMPORTANT: The
always be stored in a location protected
from moisture�
• PLEASE NOTE: After some use, your
smoker will develop a patina� Should
this rusted look not appeal to you,
you can do the following: Remove the
rust by means of a wire brush or rust-
dissolving gel� You can then coat the
surface with oven paint (heat resistant
up to at least 600 °C)� And your smoker
will once again shine like new!
smoker against
smoker should
18/11/15 11:26 AM