Connection With The Mains - EuroLite 42109230 Bedienungsanleitung

Install the mirror ball chain with the screw-on chain link at the installation eyelet of the mirror ball and tighten
the fixation screw.
Insert the fourth chain link of the mirror ball chain with the mirror ball in the screw-on chain link and tighten
the fixation screw.
For overhead use, always install a safety chain on the mirror ball that can hold at least 12 times the weight of
the installation. The safety chain must be slightly longer than the mirror ball chain so that the safety chain will
always be tension-free. Pull the safety chain through the safety eyelet of the mirror ball and in the safety
eyelet of the motor.
There must never hang a mirror ball or other load at the safety eyelet. Loads must only be hanged at the
quick link of the installation eyelet at the motor axle. If a mirror ball hangs for any reason at the safety eyelet,
the motor must be taken out of operation immediately and the mirror ball must be uninstalled. The whole
installation has to be checked for defects by an expert.
Make sure that the rotation of the mirror ball is never slowed down or stopped by decoration material etc.
Make sure that no side forces can impact on the installation.
Make sure that the mirror ball cannot be moved by air streams. The mirror ball and the motor must be
installed and operated absolutely swivel free.
Please check in regular intervals, if the installation material (e. g. key ring, shackles or screw-on chain links)
or chain links have been deformed. Uninstall the mirror ball immediately in such a case.

Connection with the mains

Connect the device to the mains with the power plug.
The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Before taking into operation for the first time, the installation has to be approved by an expert!
International
L
N
DANGER TO LIFE!
15/16 00108363.DOC, Version 2.1