Filter Change; Warranty; Troubleshooting - Wolff Compactclean Betriebsanleitung

Use breathing protection and perform this operation in a contained
area. The used filter should be placed in containment and
disposed of in the proper and prescribed method.

6.1 Filter change:

Remove the motor head. Lift the filter straight up out of the cyclone.
When required, a plastic sack can be placed over the cyclone for
dust-free filter change. The filter is lifted directly into the sack.
During the filter change, check the filter gasket. A damaged
gasket can allow the release of hazardous dust. Never use old
gaskets or after-market filters. Use only original spare parts to
maintain the unit for use on hazardous dusts. Check regularly
that the electrical cable is not damaged.
The COMPACTCLEAN should be performance tested at least
once per year because it may be used with hazardous materials.
Worn parts must be replaced. The vacuum motor is maintenance free.
6.2 Filterchange HEPA filter:
Start with to turn the motor unit up put a plastic sac over the
HEPA filter, loose the filter and seal the used filter in the plastic sac.
Then you mount a new filter according to below (Page 23)

7.0 Warranty

The warranty period for this machine is two years and covers
manufacturers faults. The warranty is valid under the condition
that the machine is used under normal conditions on the task for
which it was designed and is maintained properly. Normal wear
is not covered by this warranty. Service performed by authorized
agent voids automatically the warranty. No other warranty
express or implied is applicable.

6.0 Troubleshooting

Problem
Motor will not start.
The motor stops directly
after starting.
Fan runs but no suction.
Fan runs but poor suction. Hole in the hose.
cyclone.
Machine blows dust.
Abnormal sound from
machine.
Kompaktsauger COMPACTCLEAN, Artikel-Nr. 038909,
Downloaded from www.Manualslib.com
Fault
Machine not connected.
Incorrect fuse.
Hose not connected.
Hose plugged.
Plugged filter.
Hose too long or too small Change the hose.
Hose is kinked.
Machine top is mounted
incorrectly.
Dust is packed in the
out.
Filter is perforated or has Check the filters and
come loose.
03/2006Fugenfräse FRÄSMASTER
manuals search engine
Solution
Make sure connection.
Change to correct circuit.
Connect the hose.
Find and remove block.
Change or repair hose.
Clean or change filter.
Check and free.
Adjust the mounting.
Take offthe top and clean
change if necessary.
Order service.
13