Ruris RTS5000 ELECTRIC Handbuch Seite 23

EN
Check the wheel nuts periodically and tighten them if necessary.
Periodically check all fasteners and tighten if necessary.
Battery
Regularly examine the battery.
Always keep it clean and dry. It is recommended to fully charge the battery before each use. Always charge the
battery in an upright position. For best results, charge the battery while it is installed in the machine. The
machine should be stored in an upright position with the wheels on level ground.
Damage to the cord, plug, housing or other parts may increase the risk of fire, electric shock or injury. If
damaged, do not use the charger, replace it with a new one.
STORAGE
If the wheelbarrow will not be used for a period of more than 30 days, pay attention to the points below for proper
storage.
1. The battery must be fully charged before storage
2. Keep the battery clean and dry, do not store the entire machine in a humid environment.
3. Protect the battery from overheating and flames: danger of explosion.
4. Use clean cloths to clean the outside of the machine and keep the air vents clear.
5. Store the unit on flat ground in a clean, dry, well-ventilated area.
6. During storage, do not leave the wheelbarrow exposed to direct sunlight.
7. Before storing the battery, separate it from any electrical circuit and preferably place it in a cool, dry place.
8. During storage, disconnect the battery from the motor unit by separating the connectors and, if applicable, the
cables from the terminals.
Avoid using solvents when cleaning plastic parts. Most plastics can be damaged by various types of commercial
solvents. Remove any build-up of dirt and debris by wiping with a dry cloth.
TROUBLE
Problem
The wheelbarrow
doesn't work.
The wheelbarrow
works, but
suddenly stops.
Time short
operating time (
less than 1-3 hours
after charging )
The wheelbarrow is
moving .
slow .
The battery lights do not
turn on.
10
Possible cause
Low battery
The charger is not working.
Loose connectors.
Battery low.
The wheelbarrow
overloaded and/or the
operating conditions are
too harsh.
Charge the battery. A new battery must be
charged for at least 12 hours before using
the wheelbarrow for the first time. After the
first use, recharge the battery until the
green charging light turns on.
Check all connectors. Check that the
charger connector is connected to the
battery box and that the charger is plugged
into the outlet.
Make sure the power flow to the wall outlet
is "ON".
Contact an authorized RURIS service
center
Check all wires and connectors. Make sure
there are no loose wires.
Charge the battery.
is
Make sure not to overload the machine, the
maximum capacity is 500 kg.
Remedial solution