Technical Data - Reflexion Rcr3334 Anweisungen

REPEAT (20)
Press once = (the REPEAT (21) control lamp flashes):
the current track is repeated continuously.
Press twice = (the REPEAT control lamp lights up):
the whole CD is played continuously.
Press three times = all functions are cancelled. The normal play
mode is resumed.
Programmed Play
with the PROGRAM Button
This can be used to program any desired sequence of tracks.
1. Press the STOP (stop) button (26).
Press the PROGRAM button (25). „01" (memory preset)
2.
flashes briefly in the display. Use the
buttons (19/18) to select the desired track and then press the
PROGRAM button again. The display changes to memory
preset 02.
3. Select the next track with the
button and press the PROGRAM button again. Repeat the
procedure until all the desired tracks are selected.
NOTE:
If the maximum space available for the tracks to be pro-
grammed has been reached, the previously programmed
tracks are replaced if further tracks are entered.
4. Press the II PLAY/PAUSE button (27). The playback
starts. Press this button to pause briefly the playback.
5. Press once the STOP (stop) button to stop the playback
while retaining the program.
6. To resume the playback of the program press first the PRO-
GRAM button once and then the II PLAY/PAUSE button.
7. In order to delete the programme, press the PROGRAM
but- ton in stop mode. Then keep the STOP button pressed
down for approx. 3 sec.
The device stops automatically once the entire sequence of
programmed tracks is completed. The programmed order of
tracks remains in the memory until you change to a different
mode, remove the CD from the CD compartment or switch off
the device.
It is possible to combine the programmed tracks with the repeat
function. After you have programmed and started the device,
please press the REPEAT button (20) up to three times and then
you can use the functions as described under „REPEAT".
NOTE:
Please note these instructions for playing back CDs and
CDRs in MP3 format! The device is not able to play back
MP3 files. The CD begins to turn, but the sound cannot
be heard.
Please note:
There are a number of different recording and compression
methods, as well as quality differences between CDs and self-
recorded CDs.
11
Furthermore, the music industry does not adhere to fixed stand-
ards (copy protection).
For these reasons that there may occasionally be problems with
the playback of CDs. This is not a malfunction of the device.
Symptoms
CD can not be
played back.
I NEXT/I BACK
CD jumps during
playback.
The device cannot
I NEXT/I BACK
be operated.
Model: ................................................................... RCR3334
Power supply: ........................................................ 230 V, 50 Hz
Battery operation: ................................6 x 1,5 V, Type UM2/R14
Protection class:
Power consumption: ...........................................................12 W
Net weight:........................................................................ 1,8 kg
Radio section:
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!
Troubleshooting
Course
CD is not inserted
or inserted incor-
rectly.
Batteries too weak. Insert new batteries
Check the disc for
fingerprints, dirt or
scratches.
The device is blo-
cked, i.e. "stuck".

Technical Data

.......................................................................
Frequency ranges: .................... UKW / FM 88 ~ 108,0 MHz
....................... MW / AM 540 ~ 1600 kHz
Solution
Ensure that the
disc is inserted with
the label facing
upwards.
or operate the
device with the
mains lead.
Check the disc for
fingerprints, dirt or
scratches.
Remove the mains
plug for approxi-
mately 5 seconds.
Then turn the
device on again.