Machine Assembly - Vari Cb-800 Übersetzung Der Originalen Gebrauchsanweisung

2.14 M A
ACHINE SSEMBLY

Please request your machine set-up and training from your dealer as part of the pre-sales service.

Due to the weight of the machine, its assembly should be carried out with two workers.
•
The machine is delivered in two boxes - the machine base is in the box marked
Fig. 32 on page 107
1. Remove all loose machine parts from box
2. Sort the fasteners from the bag with Operating Instructions.:
3. Cut the box at all four corners and fold the sides and fronts down.
4. Cut the plastic strips that fix the handlebars
5. Lift the machine up slightly by pulling on the handlebar holder
machine axle.
6. >1 and >2 : The other worker puts flat washers
right wheel 4 . He will secure the wheels with their locking pins with caliper

Make sure the wheel tread direction matches the image in Fig. 32 . The wheel direction arrow on the side of the tyre labelled
ROTATION .
7. Lower the machine onto the wheels.
8. Lift and turn the handlebars by 180°.

Make sure the Bowdens are not crossedd!
9. >3 : Fit the handlebars
mm 10 , lightly lubricate the bolt tread end. Screw on the plastic star
10. Secure the Bowdens via two plastic tie straps
fasten the throttle Bowden and brush drive actuation Bowden to the right handlebar handle.
11. >4 : Lubricate the thread in the support wheel. Insert the support wheel
extreme position. Turn the control knob a few times
The machine will stand on its own now.
12. >5 : To the support plate on the brush drive
brush position setting lever
13. >6 : To the support plate on the brush drive
: Depending on the selected brush width (see Fig. 31 ) Screw the fenders onto the brush drive support plate
14. >6
22 via the screw connections
plastic fender side.
15. >7 : Slide the bolt into the hole in the square
of the brush drive. Slide the square drift tube
screw on the self-locking collar nut
16. Follow the procedure in Chap. 2.7.5 Brush change on page 35 and Fig. 27 Attach your selected brush width.
40
A and the brushes from box
7 on the cardboard insert. Remove the cardboard insert.
1
7 to the handlebar tubular bracket
12 to the handlebar handles
15
16 via screws
20 . Tighten the screw connection, so the rubber columns
16 Using the screw connection,
A and B . The flat washer in screw connection
24 drift tube
24 onto the hexagonal output shaft
28 . Tighten securely.
A , the brushes in the box marked
B .
8 . The other worker will remove the cardboard insert under the
21 mm 2 , lubricates the axle shaft ends and fits the left wheel
5 and locking rings
8 , insert the bolt from the left
11 and tighten it securely.
7 at the point before the first tube bend. Jointly
13 from below into the square tube
to the right, so the support wheel engages with the control knob screw.
17 with nuts 18 and inserted rubber columns
B attach the connecting sheet metal part
B must always be under the screw head on the
25 . Slide the bolt into the hole in the hexagonal output shaft
CB-800 CB-1000
B .
6 .
9 , insert the flat washer 8.4
19
19 get only slightly compressed.
26 . Slide the other drift square tube
3 and
14 to the
attach the
23 .
16 21 and
26
27 ,