Noise And Vibrations Levels; Safety Pictograms; Basic Information; Use Of The Machine - Vari Cb-800 Übersetzung Der Originalen Gebrauchsanweisung

2.2.2 N V
OISE AND IBRATIONS
Description
Declared acoustic pressure emission level A at the operator's site
Declared acoustic output level A
Declared cumulative value of the acceleration of vibrations transmitted to the operator's
hand-arm 43 a
hv,d
Table 13: Measured Noise and Vibrations Levels
2.2.3 S P
AFETY ICTOGRAMS
The user is obliged to keep the pictograms on the machine in a readable state and, in case of any damage, ensure their replacement.
Position:
Combined sticker ( Fig. 34 ), which is
attached on the rear plastic cover.
Sticker ( Fig. 37 ) on the control lever on
the right handle.
Sticker ( Fig. 36 ) on the control lever on
the left handle.
Table 14: Safety Pictograms
2.3 B I
ASIC NFORMATION
2.3.1 U M
SE OF THE
CB-800
Sweeping brush
the height of 3 cm 45 .

It is forbidden to work with the machine on roads of all classes, except to drive perpendicularly over them only
where permitted.

Before using the machine, always check that the bristles of the sweeping rollers do not damage the surface of the
area to be swept!
OR-80
With a snow plough
For collecting dirt, we recommend using the
When working in areas where there is a risk of damage to property or injury to other people, we recommend using the dust cover AP-100 .

The aforementioned accessories are not included in the machine, they can be purchased separately.

The use for purposes other than the intended purpose is; therefore, to be considered a use for an unspecified
purpose!
Measured per ČSN EN ISO 11201
41
42 Per ČSN EN ISO 3744
43 Measured per ČSN EN ISO 20643
44 For example, concrete or bituminous surfaces, concrete or granite paving, poured floors, etc.
45 Depending on the type of snow. During snow removal, a certain amount of snow can always get into the area behind the sweeping rollers on the surface to be cleaned. This
condition is quite normal and does not give rise to a claim for malfunctioning of the machine.
L
EVELS
42 L
WA,d
Number: Description:
1 Before using the machine, read through these Operating Instructions.
2 When doing maintenance on the machine, disconnect the spark plug connector.
Risk of being hit by flying debris, cuttings, ejected items, etc.
3
Other persons and animals - keep a safe distance from the machine.
4 During work observe the maximum permissible slope for operation.
5 Use eye and hearing protection.
6 Wear respiratory protection
Starting the working tool drive:
0 = working tool not moving
-
1 = working tool moving
Machine travel start:
0
= the machine is stationary
-
1
= The machine is moving
ACHINE
CB-1000
or is designed for the cleaning of flat artificial surfaces
ROR-1000
or it is possible to clear a freshly fallen snow layer with the height of up to 10 cm.
BS-80 BS-100
or
41 (L )
pAd
dump box.
CB-800 CB-1000
CB-800 CB-1000
(82+4) dB
(83+4) dB
(96+4) dB
(97+4) dB
(8.8+3.5) m.s -2 (9.7+3.9) m.s
44 with dirt or freshly fallen snow up to
-2
25