Function „Auto Switch Display Setting; Function „Video Segment Sizes - Renkforce 1000562 Bedienungsanleitung

Function „Auto Switch Display Setting"
Here, the time interval for auto mode (see chapter 10 c) can be set. In the basic setting,
the time interval is 5 seconds.
Proceed as follows:
• Use the buttons „2" and „8" to pick the function „Auto Switch Display Setting" and
then push „
„Dwell Time Setting" appears. Push „
• Set the desired time interval in the range of 2 - 60 seconds with the buttons „2" and
„8".
• Confirm the setting with „
• Push the button „MENU/ESC" on the digital recorder or the button „MENU" or „ESC"
on the IR remote control repeatedly to return to the respective previous menu or leave
the OSD menu.
Function „Video Segment Sizes"
Set the maximum length of the individual video files (for manual recording or automatic
recording). You can set 5, 10, 15 or 30 minutes.
Power outage, error on the memory card, etc. may cause damage to the re-
cording. A short time setting (e.g. 5 minutes) has benefits here but will cause
many video files to be crated in case of long recordings. These are difficult to
play back.
Proceed as follows:
• Use the buttons „2" and „8" to pick the function „Video Segment Sizes" and then
push „ ".
• Use the buttons „2" and „8" to set how long the individual video files are allowed
to be (can be set to 5, 10, 15 and 30 minutes).
• Confirm the setting with „
• Push the button „MENU/ESC" on the digital recorder or the button „MENU" or „ESC"
on the IR remote control repeatedly to return to the respective previous menu or leave
the OSD menu.
74
".
".
".
" again.