Renkforce 1000562 Bedienungsanleitung Seite 175

G Operating instructions
CMOS Colour Camera, 600 TVL, 4.3 mm
Item no. 80 85 82
Intended use
This camera is intended for monitoring and protecting secluded or critical areas (e.g.
entrance areas, surveillance of underground car parks, stairwells and the like).
The product is designed for use indoors and outdoors (IP65).
The camera is intended to be used only with a stabilised mains voltage of 12V/DC.
Please bear in mind that it is prohibited by law to observe strangers with a camera
without their knowledge and consent. Observe the rules and regulations of the country
where you are using the camera.
The safety instructions must be observed at all times!
Any use other than that described above could lead to damage to this product and
involves the risk of short circuits, fire, electric shock, etc. No part of the product may
be modified or converted!
This product complies with the applicable national and European requirements. All
names of companies and products are the trademarks of the respective owners. All
rights reserved.
Contents
• Colour camera
• Extension cable
• Mounting material (wall bracket, screws, wall plugs)
• Operating instructions
Explanation of the symbols
This symbol indicates specific risks associated with handling, function and
use.
The "arrow" symbol indicates special tips and operating information.
Safety Instructions
The warranty will be void in the event of damage caused by failure to
observe these safety instructions! We do not assume any liability for any
resulting damage!
We shall not accept liability for damage to property or personal injury
caused by incorrect handling or non-compliance with the safety instruc-
tions. In such cases, the warranty will be null and void.
• The unauthorised conversion and/or modification of the product is
not permitted for safety and approval reasons (CE). Never dismantle the
product.
• The camera is intended to be used only with a stabilised direct current of
12 V/DC.
• The product is not a toy and should be kept out of the reach of children. It
should be operated out of the reach of children.
• The use of the surveillance camera does not replace the personal supervi-
sion of children or people who require special assistance, but serves only
as a support to this supervision.
• The camera is suitable for use in indoor and outdoor areas (IP65). How-
ever, it must never be used in or under water, as this will destroy it.
• The camera must not be exposed to extreme temperatures, direct sun-
light, strong vibrations or heavy mechanical stress.
• Make sure that the connection cable is not pinched or damaged by sharp
edges.
• Do not carelessly leave the packaging material lying around, since it could
become a dangerous plaything for children.
• Handle the product with care; it can be damaged by impacts, blows or
falls even from a low height.
• If the camera is used with other devices (e.g. a monitor), the operating
instructions and safety notes for these devices must also be followed.
• Safe operation can no longer be assumed if:
- the device is visibly damaged,
- the device no longer works
- the device has been stored under adverse conditions for a long time
- it was exposed to heavy loads during transport
• On industrial sites, the accident prevention regulations of the associa-
tion of the industrial workers' society for electrical equipment and utilities
must be followed.
• If you have any questions that are not answered in this manual, please
contact our technical service or another specialist.
Installation
The camera should not be pointed directly towards bright sources of light or
the sun, since this will overexpose the image.
For outdoor use, we recommend that you choose a location that is protected
from rain/sprayed water (e.g. under the eaves) to prevent the formation of
droplets or accumulation of sprayed water on the camera's front panel that
will cause a distorted and unusable image.
• The wall bracket and threads at the top and bottom of the camera make installation
on a wall or ceiling possible.
• Depending on the mounting location, use appropriate screws and, where neces-
sary, wall plugs to attach the bracket.
Make sure when screwing into place or when drilling holes that cables or wires are
not damaged.
• Install the cable in a suitable place.
Use e.g. suitable cable ties to fix the cable. Alternatively, the cable can also
be placed in a cable channel or similar. This will also serve as protection
against acts of sabotage.
We recommend not placing the cable directly next to power cables, if pos-
sible, as this may affect the video image.
Protect the cable from sharp edges and do not bend it.
If the plug of the cables is to be put, for example, through a hole in a wall,
protect the plug from dust and dirt using, for example, with a small plastic
bag.
Connection
The camera has an RJ11 plug at the end of the cable. This is used to connect suitable
devices (e.g. a digital video recorder, DVR) with a corresponding RJ11 socket.
The power supply of the camera as well as the transmission of the video
signal from the camera to the DVR is done via this RJ11 connection.
For this reason, a separate power adapter is not necessary for the camera.
Insert the RJ11 plug into the corresponding socket of the DVR so that the clip on the
RJ11 plug clicks into place inside the RJ11 socket of the DVR.
Set the correct input channel to display the camera image.
Afterwards, adjust the camera again if needed, in order to be able to monitor the
desired area.
In the dark, the IR LEDs of the camera are activated automatically. However,
the LEDs are not visible to the human eye. Please bear in mind that at night,
coloured image reproduction changes into a black and white monochrome
representation as a matter of principle.
Cleaning
Occasionally, clean the camera from dust and dirt, especially the front screen. To that
effect, use a clean, soft, dry cloth. Do not rub too hard, since otherwise scratch marks
will occur on the glass; this will cause deterioration in the image quality!
Never direct a stream of water from a garden hose or a high-pressure cleaner, or
similar, onto the camera.
Do not use any aggressive detergent, as this might cause discolouration.