Renkforce 1000562 Bedienungsanleitung Seite 71

2. „Motion Detect"
The recording is started when the digital recorder recognises a motion in the monitored
area. The sensitivity of the motion detection can be set. A specific image section can
also be specified for motion detection (see description of the function „Motion Detect
Setup").
A special feature is the pre-recording with the motion detection switched on
(„Pre-Recording"). This means that the digital recorder will also save the 2
seconds from before motion recognition when a motion is recognised in the
monitoring area.
The recording ends when the digital recorder has no longer recognised any motion for
a duration of about 10-15 seconds.
3. „Schedule"
You can set a specific time here at which a recording is to take place automatically
(time-controlled recording). It is possible to programme only one specific day (e.g. next
Saturday) or have the recording take place every day (e.g. 8:00 AM to 6:00 PM).
The recording of photographs is only possible in the operating mode „One Key".
If you chose the operating mode „Motion Detect" or „Schedule" in the function
„Recording mode", the recording of videos is activated automatically.
Proceed as follows:
• Use the buttons „2" and „8" to pick the function „Recording Mode" and then push
„ ".
• Use the buttons „2" and „8" to set the desired operating mode („One Key", „Motion
Detect" or „Schedule"), see description above.
• Confirm the selection with „
If the operating mode „Schedule" was chosen, set when the automatic recording
is to take place. This setting can be made separately for channel 1 („CH1") and
channel 2 („CH2").
First use the buttons „2" and „8" to choose between channel 1 („CH1") and channel
2 („CH2"); the respective active channel is marked with a red frame.
Push this button „
".
" to start the settings.
71