Charging the Headset
Insert the USB charging cable into the USB port which supports 5V power (such
•
as AC/DC USB adapter or PC USB port). When the red light is on, the headset is
charging. When the red light will be off, the headset is fully charged. It takes
about 2 to 2.5 hours to charge the headset fully.
The battery is rechargeable. Low-voltage alert: When the alert tone "Low battery"
•
sounds and the indicator turns red, that indicates that the battery has run out,
needs to be charged as soon as possible. When charging for the first time, please
be sure the battery has been charged fully before use.
Wireless Headphone Function
For any mode of headphone, you can connect one side of 3.5 stereo sound supply
extension line to headphone audio jack, another side connect to audio jack (such as
mobile phone, computer, iPad, etc.). Then you will hear songs from other devices.
Switch Mode – 85dB / 94dB
In order to change the volume sensitivity, hold [+] and [-] buttons at the same time till
you hear the voice prompt "85dB" or "94dB".
Resetting the Headphones
Hold both [M] and [-] buttons for 4-7 seconds in order to reset the Bluetooth and enter
pairing mode again.
CE
Hereby GL Grup-2015 LTD declares that wireless headphone PowerLocus P2 Kids is in
compliance with essential requirements and other relevant conditions of Directive
2014/53/EU. The full text of the EU declaration conformity is available at the following
internet address: (powerlocus.com/doc)
Frequency: 2402-2480 MHz
Max radio frequency power: 100 mW (EIRP)
GL GRUP-2015 LTD. 36 VASIL LEVSKI STREET, 5370 DRYANOVO, BULGARIA
WEEE
This symbol on a product means that the product is covered by European Directive
2012/19/EU. Electrical products should not be disposed of with household waste. Please
recycle them at the collect points provided for this purpose. Contact the local
authorities or your dealer for recycling advice. Proper disposal of old appliances helps
preserve the environment and health.
5