Voice Prompts; Charging The Headphones - Powerlocus Pled Benutzerhandbuch

Activate voice assistant
Clear the pairing list
Turn on/off LED lights

Voice Prompts

Power on
Power off
Pairing
Successful pairing
Disconnection
Low power

Charging the Headphones

Connect the USB Type C cable to the Type C port on the headphones and connect the
cable to a 5V power adapter (power adapter is not included in the package). The
indicator light will glow red to indicate charging. When the headphones are fully
charged, the indicator light will change from red to blue.
CE
Hereby GL Grup-2015 LTD declares that wireless headphone PowerLocus PLED is in
compliance with essential requirements and other relevant conditions of Directive
2014/53/EU. The full text of the EU declaration conformity is available at the following
internet address: (powerlocus.com/doc)
Frequency: 2402-2480 MHz
Max radio frequency power: 100 mW (EIRP)
GL GRUP-2015 LTD. 36 VASIL LEVSKI STREET, 5370 DRYANOVO, BULGARIA
Press the multifunction button twice.
Press and hold the [+] and [-] buttons
simultaneously for five seconds in the
pairing mode to clear the pairing list.
Then the headphones will automatically
enter pairing state.
Short press the [M] button.
"Power on."
"Power off."
"Pairing."
"Connected."
"Disconnected."
"Battery low."
6