Nature7 SJ200ST Bedienungsanleitung Seite 17

User's Manual
IV. Juicer Assembly
c
CAUTION
Read carefully the operation manual before assembling and using
the juicer.
The manufacturer is not responsible for product damage or
potential injuries that are caused by improper or careless use of the
juicer.
Include the instructions for use if you lend out or sell on the juicer
and avoid damaging this manual.
8
Thoroughly rinse all parts that shall come into contact
with foodstuffs before the initial use of this product!
1 Make sure that the circular silicone sealing and silicone sealing
plug are in good condition before placing the stock tank to the
juicer motor. Then insert the silicone plug into the waste outlet
opening, otherwise the juice will overflow out of the stock tank
M
( Fig. B).
2 The juicer stock tank rotates as such, that the arrow at the
lower edge of the stock tank is set in the unlatched lock position
on the device body and after it has been set in place, turn it into
M
the latched lock position. ( Fig. C+D+E).
3 The sieve embedded within the adjusting sleeve with spatula
type device rotates as such, that the arrow on the sieve is set in
the marking place on the side of the stock tank, afterwards, it
is possible to set it on the stock tank itself. Make sure that the
adjusting sleeve with spatula type device is correctly fitted in the
M
stock tank. ( Fig. F+G).
4 Insert the screw shaft into the opening in the centre of the
stock tank. When juicing root vegetables and celery stalks into
the screw centre, attach the supplied slicer for pre-cutting (part 7)
M
( Fig. H).
If everything is not aligned correctly, the cover with the filler can not
be screwed into the stock tank.
5 The cover with the filler neck rotates as such, that the
unlatched lock symbol on the cover is at the place of the triangle
on the side of the stock tank. After setting the cover into the stock
tank, the cover is to be turned into the latched lock position (
Fig. I+J+K).
c
NOTE
If the juicer system is not assembled and set properly, the motor
cannot be activated due to an interlock switch, that serves
as a protection against damage because of poorly deployed
components.
6 Turning of the silicone sealing position in the outflow status
M
can regulate the flow (
7 Place containers under the outlet for collecting juices and
wastes and insert the spile into the filler neck. The juicer is now
M
ready for use ( Fig. M).
V. Disassembling the Juicer
System
c
NOTE
Before disassembling, unplug the power cord from the mains.
Proceed in the reverse order of assembly for disassembly steps.
VI. Switch On/Off/Reverse
Before plugging the power cord into the mains, check whether the
mains voltage corresponds to the range of 220-240 V. The device can
be used in this voltage range
The socket must be three-pin (ground), since the juicer is insulation
M
class I. ( Fig. N)
→
Press the knob to turn on (screw rotation)"ON/OFF".
→
To turn off, press the same knob.
→
For rotation movement in the opposite direction in case
of blockage hold down the "REV" knob. When you release the
button, the movement stops. For the restoration of the original
direction of rotation, press the "ON / OFF" knob.
8
After pressing the knob, a red indicator light will light up in
the knob.
M
∆
Fig. L).
17