Bluetooth ® Pairing - Hama Touch Bedienungsanleitung

• Disconnect all cable and mains connections after use.
6. Operation
Switching the headset off/on
• Press the MFB button (2) until a voice says "Power ON" and
the blue LED (4) flashes.
• To switch it off, press and hold the MFB button (2) until a voice
says "Power OFF" and the red LED (4) flashes.
Note
The functions described in this section are only available for
Bluetooth -capable terminal devices.
®
6.1. Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
on and Bluetooth is activated.
®
• Make sure that your Bluetooth
visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should not be any further
than 1 metre away from each other. The smaller the distance,
the better.
• Switch the headset on using the MF button (2).
• Press and hold the MFB button (2) for about 5 seconds
until a voice says 'PAIRING' and the blue and red LEDs (4)
flash alternatingly. The headset is searching for a Bluetooth
connection.
• Open the Bluetooth settings on your terminal device and
®
wait until Hama BTH TOUCH appears in the list of Bluetooth
devices found.
• Select Hama BTH TOUCH and wait until the headset is listed as
connected in the Bluetooth
Note – Bluetooth
Some terminal devices require a password in order to connect
to another Bluetooth device.
®
• If your terminal device requests a password for connection
with the headset, enter 0000.
-capable terminal device is
®
-capable terminal device is
®
devices.
®
settings on your terminal device.
®
password
®
Note
• Once the connection has been established, a voice says,
"PAIRED".
• If the connection attempt takes longer than 300 seconds to
complete, it is cancelled and the LEDs go out. In this case,
repeat the steps listed previously under 5.1 Bluetooth
pairing.
6.2. Automatic Bluetooth
pairing)
Note
• Make sure that your Bluetooth
on and Bluetooth
• Make sure that your Bluetooth
visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• Switch the headset on using the MFB button (2). The blue LED
begins to flash and the headset automatically connects with the
last terminal device used.
Note
• Once the connection has been established, a voice says,
"PAIRED".
• If the connection attempt takes longer than 300 seconds to
complete, it is cancelled and the LEDs go out. In this case,
®
repeat the steps listed previously under 5.2.
• It may be necessary to make settings on your terminal device
to enable automatic connection with the paired headset.
®
connection (after successful
®
-capable terminal device is
®
is activated.
®
-capable terminal device is
®
devices.
®
®
3