Change Slave - Siemens OP1S Betriebsanleitung

OP1S Operator Control Panel

4.2 Change slave

During bus operation, a specific slave can be selected via the OP1S with the "Change
slave" function without any re-plugging. Starting from the basic menu, the "Change slave"
function is selected with the "Lower"/"Raise" key and activated with "P". The user is then
requested to enter a slave address.
P
Ì Î
MotionControl Change slave
Download Address:00
Delete data
# Change slave
After the slave address has been entered with "Raise"/"Lower" and confirmed with "P", a
change is made to the required slave and the display returns to the basic menu. If the
slave cannot be found, an error message is output.
Siemens AG 477 459 4070 76 J AA-74
SIMOVERT MASTERDRIVES Operating Instructions
Example of activating the "Change
slave" function
23