OP1S Operator Control Panel
Contents
1
General ...............................................................................................................1
2
Connecting, Run-up ..........................................................................................3
2.1
Connecting ..........................................................................................................3
2.2
Run-up.................................................................................................................5
3
Operator control ................................................................................................7
3.1
3.2
Operating display.................................................................................................8
3.3
Basic menu..........................................................................................................9
3.4
Slave ID.............................................................................................................10
3.5
OP: Upread........................................................................................................11
3.6
OP: Download....................................................................................................12
3.7
Delete data ........................................................................................................13
3.8
Menu selection ..................................................................................................14
3.8.1
3.8.2
3.9
4
Bus operation ..................................................................................................22
4.1
Configuring slaves .............................................................................................22
4.2
Change slave.....................................................................................................23
5
Technical data..................................................................................................24
This operation manual of the OP1S is only valid for MASTER DRIVES
Note
units with the control boards CUVC and CUMC and for MASTER
DRIVES Kompakt+ units.
The usage of the OP1S as spare part for the OP1 in conjunction with
the control boards CU1 (FC), CU2 (VC) and CU3 (SC) is described in
the operation manual of the OP1 with the order No. : 6SE7087-6CX84-
2FF0.
Siemens AG
477 459 4070 76 J AA-74
SIMOVERT MASTERDRIVES
Operating Instructions