Hama Add-On Bedienungsanleitung Seite 37

5.2 Installation
Warning
• Before mounting, check that the wall you have chosen
is suitable for the weight to be mounted. Also make
sure that there are no electric, water, gas or other lines
running through the wall at the mounting site.
• Do not mount the product above locations where
persons might sit or stand.
• We recommend attaching the sensor to the window
or door frame and securing the device directly to the
window / door.
• Ensure that the markings (triangles) of the device and
sensor are in a straight line and when the door / window is
closed are no more than 10 mm apart.
• You can either screw the device and sensor in place or
use adhesive pads.
• If a door leaf or window juts out, the sensor can also be
attached to the side and the device secured flat to the
frame.
Warning - installation with adhesive
• All parts are suitable only for use indoors. Do not install
outdoors.
• Be aware that the intended mounting surface must be
free from dust and grease. Use a suitable cleaner from
a specialist retailer for this.
• Be aware that the adhesive pads are intended to be
permanent. Carefully pull the adhesive pad off the
mounting surface to remove it.
• Various environmental influences, such as moisture in
the air, sunlight, cold, etc., can impair the long-term
stickiness of the adhesive pads.
• Possible residue on the mounting surface after removal
of the adhesive pads cannot be ruled out!
4