Icy Box IB-RP104 Schnellinstallationsanleitung Seite 6

Quick installation guide IB-RP104
Important product information
Dear customer, please note the following information about the main boards
which are supported by this device!
Requirements and information
• Compatible with: Raspberry Pi
B and Model B+
• No GPIO cable cut out, no status LED cut out for Pi
• Raspberry Pi
Packing content
1x IB-RP104, 1x set of heat sinks, 1 set of thermal pads, 1x set of screws, 4x
footpad stickers, 1x screw driver, 1x quick installation guide (Raspberry Pi
included)
Protective case for Raspberry Pi
This Raspberry Pi case is a small form factor aluminium case designed for perfor-
mance and comfort. The case cools down the Raspberry Pi CPU and USB chip
thanks to its aluminum construction and included heatsinks and thermal pads.
The case is acting as a passive heat sink that improves the single board computer
performances.
Key Features
• Protective enclosure designed specifically for the Raspberry Pi
• Quality aluminum casing to dissipate heat and contains an antenna
mount hole
• Including two heatsinks and thermal pads to conduct heat from CPU to
aluminum case
• All cut-outs for each interface are pre-cut into the sides of the enclosure
• Allows easy access to power, video, audio, USB, LAN, microSD card
• Prepared for wall mounting
Assembly
• Please follow the drawing to assemble the appropriated board to the IB-RP104.
• The heat sinks can be placed to the main chip sets on the board accordingly
to their sizes.
Please remove the foils of the thermal pads at both sides before stick them to the PCB.
board and antenna not included
®
1 Model B+, Pi
®
2 and 3
®
2 Model B, Pi
® ®
2
®
2 and 3
®
3 Model
not
®