How To Use Clutch Bite Point; Recommended Procedure For Finding Suitable Bite Point Setting; Recommended Procedure For Quick Race Starts - Ascher Racing F64-Usb V3 Produktanleitung

2. Analog Input Mode
- Throttle and Brake: two separate axes for both clutches.
- Dual Clutch: one single axis for both clutches, both signals are compared, and whichever signal
is greater will be the output.
3. Master Clutch
- Set which clutch is the master clutch.
- Master clutch will not be affected by clutch bite point setting.
- Slave clutch is scaled down so that 100% mechanical throw equals clutch bite point.
4. Clutch Bite Point: set the value of slave clutch at 100% mechanical throw.
5. Rotary Switch Mode:
- 12 Way Rotary: constant button presses of the rotary switch.
- 12 Way Rotary Pulsed: pulsed button presses of the rotary switch.
- Encoder: pulsed button for each clockwise and anti-clockwise rotation.
- Shift Encoder: one rotary switch acts as selector, the other one as encoder -> use 12 encoders
for various settings this way.
6. Encoder Pulse Width: set the duration of button presses of encoders.
7. LED Intensity: adjust intensity of the bite point calibration mode signal LED.
8. Inputs: shows all available inputs (must not show every single encoder step due to update
cycle).
9. X-Axis/ Y-Axis: output of left/ right clutch
- linearity modes: linear, progressive/ degressive, S-Curve
- dead zones: adjust buffer between electrical and mechanical throw, LOW = start/ HIGH = end
10. Calibrate:
1. Set Analog Input Mode to Throttle and Brake,
2. release clutch and click Set Low,
3. pull clutch fully and click Set High.

8. How to use Clutch Bite Point

Recommended Procedure for Finding Suitable Bite Point Setting

1. Enter calibration mode and set bite point to high value, e.g. 80 %.
2. Pull slave clutch only.
3. Apply throttle.
4. Reduce bite point in 1.0 % increments (left joystick) until vehicle starts moving.
5. Make test starts to fine tune desired bite point setting.
6. Exit bite point calibration mode.

Recommended Procedure for Quick Race Starts

1. Pull both clutches (master and slave).
2. Apply throttle.
3. Race start → let master clutch snap (it will take less than 20 ms to reach desired bite point).
4. Slowly release slave clutch.
ENGLISH | GERMAN
9 | p a g e