Safety Information; Intended Use; Battery Warnings; Declaration Of Conformity - Ascher Racing B24L Produktanleitung

1. Safety Information

Thank you for purchasing the Ascher Racing B24 button plate. Please read the manual carefully before
installing and using the product.

Intended Use

The button plate is designed to be used in a competitive sim racing environment for indoor use only and
connects wirelessly to a Simucube receiver.
Please note the following general safety aspects:
- The device must not be exposed to rain or humidity to avoid the risk of fire and electric shock.
- Do not operate or store the device outside of room temperature, 15°C to 35°C
- We strongly advise you not to drive a vehicle immediately after driving a racing simulation.
- This product is not intended for children under the age of 15 years.
- Contains small pieces – danger of swallowing!
- Extended periods of driving a simulation may cause health risks. Take a break of 5 minutes every
20 minutes and do not exceed 2 hours of total driving time per day.
- Keep hair, clothing and jewelry away from the product when in use.
- Only one person may use the product at any given time. Keep other persons away from the product
when in use.
- Do not disassemble the product beyond what is described in this product manual.
- Make sure the steering wheel is mounted securely to your wheel base and screws are tightened
properly before use.
- Do not leave the device exposed to a heat source or in a high-temperature location, such as in the
sun in an unattended vehicle. To prevent the possibility of damage, remove the device from the
vehicle or store it out of direct sunlight.

Battery Warnings

A lithium battery is used in this device. If these guidelines are not followed, batteries may experience a
shortened life span or may present a risk of damage to the device, fire, chemical burn, electrolyte leak,
and/ or injury.
- Do not modify, remanufacture, puncture or damage the device or battery.
- Only remove or attempt to remove the battery when device is turned off via hardware switch.
- Do not expose the device to fire, explosion or another hazard.

2. Declaration of Conformity

It's in conformity with the essential requirements and other relevant requirements of the Radio Equipment
Directive (RED) (2014/53/EU).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause
undesirable operation.
Any changes or modifications not expressly approved by KW automotive GmbH could void the user's
authority to operate the equipment.
ENGLISH | GERMAN
3 | p a g e