Ikra GHSI 7560 Pro Gebrauchsanweisung Seite 20

of the tool. Damaged or tangled cables
increase the risk of electric shock.
e) When operating a power tool out-
doors, use exclusively extension ca-
bles that are approved for outdoor-
use. The use of an extension cable that
is suitable for outdoor use reduces the
risk of electric shock.
3) Personal safety
a) Always pay attention to what you do
and apply reasonable care when work-
ing with a power tool. Do not use the
tool when you are tired or under the
influence of medication, drugs or alco-
hol. When working with power tools even
a short moment of inattentiveness may
result in severe injury.
b) Wear personal protection equipment
and always wear eye protection (safe-
ty goggles). Wearing personal protection
equipment as a dust mask, nonslip safety
shoes, safety helmet or ear protectors
(depending on the type and use of the
tool) reduces the risk of injury.
c) Avoid unintentional operation. Make
sure that the switch is in 'OFF' posi-
tion before pulling the plug from the
mains socket. When carrying the tool
with your finger on the on/off switch or
connecting the tool to the mains supply
with the switch in 'ON' position, this may
result in accidents.
d) Remove adjustment tools or wrenches
and the like before you switch the tool
on. A wrench or another tool that is inside
or on a turning part of the tool may cause
injury.
e) Do not overestimate your abilities.
Take care of a safe footing and keep
your balance at all times. This will allow
you to better control the tool in unex-
pected situations.
f) Wear suitable clothes. Do not wear
wide clothing or jewellery. Keep your
hair, clothes and gloves clear of all
moving parts. Loose clothing, jewellery
or long hair may get caught in moving
parts.
g) If dust extraction/collection devices
are provided make sure that they are
connected and used properly. The use
of these devices reduces hazards caused
by dust.
4) Careful handling and use of power tools
a) Do not overtax the power tool. Use the
power tool intended for your type of
work in each case. The use of the suit-
able power tool within the stated range of
performance makes working more effec-
tive and safer.
b) Do not use a power tool with a dam-
aged switch. A power tool that cannot be
switched on or off any more is dangerous
and must be repaired.
c) Pull the mains plug out of the socket
before you adjust a tool, change ac-
cessories or put the tool aside. This
precaution avoids the unintentional start
of the tool.
d) Store power tools out of the reach of
children. Do not allow persons to use
the tool if they are not familiar with the
tool or these instructions. Power tools
are dangerous if used by inexperienced
persons.
e) Thoroughly maintain your power tool.
Check whether moving parts are work-
ing properly and are not jamming/
sticking, and whether parts are broken
or otherwise damaged in a way that
affects the function of the tool. Have
damaged parts repaired before using
the tool. Many accidents are the result of
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Thoroughly looked-after cutting tools with
sharp cutting edges are jamming less
often and are easier to guide.
g) Use power tools, accessories, add-on
tools, etc. in accordance with these
instructions and in the way prescribed
for the respective type of tool. You
should also consider the working con-
ditions and the work to be carried out.
The use of power tools for purposes other
than those intended for the respective
tool may result in dangerous situations.
5) Service
a) Have the power tool serviced by quali-
GB-4