Oase ProMax Garden Automatic 3500 Gebrauchsanleitung Seite 16

6. Undo the water drain screw and tip the
pump to allow the residual water to drain
out.
7. Screw in the water drain screw again.
OPERATION
1 Blue LED
2 Yellow LED
3 Red LED
4 ON/OFF button
16
Cycle: Sensors monitor the water flow
•
and the water pressure, and switch the
pump on, off or into standby after a cer-
tain time when the pump cannot extract
any more water or the pressure line is
closed.
The lit or flashing LEDs in the ON/OFF
•
button indicate the respective operating
status. (→ Operating status and at-
tendant LED displays)
Establishing operational readiness:
Connect the pump to the power supply.
The pump is ready for operation.
POX0041 •
All LEDs are lit.
•
For switching the pump on and off:
Press the ON/OFF button for less than 3 s.
– Once it is switched on, the automatic
mode takes control of the pump:
Sensors repeatedly monitor whether
the water flow is below the minimum
flow rate or the water pressure below
1.5 bar. Depending on the result, the
pump is either operated with dry-run
protection or is switched back into
standby by automatic mode.
Resetting automatic mode: Press the
•
ON/OFF button for at least 3 s.
ProMax Garden Automatic 3500/4000/5000/6000