Buttons Description; Installation Requirements - Fs Vms-503C Schnellstartanleitung

Back Panel Buttons
Buttons Description
· Press and hold the button to shut down the device.
PWR
· Press it again to start the device.
RST
The device is communicating with the disk enclosure.

Installation Requirements

Before the installation, make sure that you have the following:
Flathead screwdriver, Phillips screwdriver, a pair of antistatic gloves or an antistatic wrist
strap.
Standard-sized, 19" wide rack with a minimum of 4U height available.
Ethernet crossover cables, console cables and SAS cables.
Site Environment
Make sure that the working temperature is maintained at 10°C~35°C, and the relative
humidity is maintained at 20%~80%.
Store or use the device in a proper environment that meets environmental requirements,
including and not limited to, temperature, humidity, dust, corrosive gases, electromagnetic
radiation, etc.
Make sure that the device is securely installed or placed on a at surface to prevent falling.
Unless otherwise speci ed, do not stack devices.
Make sure that there is good ventilation in the operating environment.
Precautions
Always disconnect the device from the power before attempting to move the device.
Do not attempt to service the product yourself. Contact a trained professional for
maintenance.
The product may collect personal information, such as facial recognition, ngerprints,
license plates, email addresses, phone numbers, and GPS data.
4
PWR RST