Shutting Down; Transport; Storage - Kärcher BDS 43/180 C Adv Betriebsanleitung

Warning
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded.
In case of confusion regarding the power
impedance present on your connection,
please contact your utilities provider.
 Set handle to working height.
 Hold the handle with both hands.
 Press and hold the unlocking button.
 Activate the switch.
 Release the unlocking button.
 Release the switch to interrupt operation.
Control the direction
Left: Press the handle downward.
–
Right: Raise the handle.
–
Cleaning
 Apply the detergent solution to the floor
or use the dosing lever (accessory).
 Move the appliance over the surface to
be cleaned.
 Afterwards, pick up the wastewater with
a wet vacuum or a cloth.

Shutting down

 Release the switch.
 Disconnect the mains plug from the
socket.
 Pull the lever for level adjustment and
bring the handle in a vertical position.
 Swivel the top cable hook upward and
wind the cable between the two cable
hooks.
 Remove the detergent tank (accessory)
and dispose of unused detergent solu-
tion.
 Rinse the detergent tank (accessory)
with clear water.
 Pull the lever for level adjustment and
bring the handle toward the front into a
vertical position.
 Place the appliance into the parking po-
sition.
 Clean the casing with a damp cloth.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Swivel the handle vertically and lock it.
 Tilt the appliance backwards into the
transport position and drive it to its des-
tination location.
Caution
Risk of damage! Only transport the appli-
ance on the wheels; the small rollers on the
bottom of the cleaning head are not suita-
ble to be used for transport.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
 Pull the lever for level adjustment and
bring the handle toward the front into a
vertical position.
 Place the appliance into the parking po-
sition.
 Store the appliance in a dry room, frost-
protected room.
– 4
EN

Transport

Storage

15