Product Installation; Maintenance; Disposal - Key Automation Spark03 Anleitungen Und Hinweise Zu Installation Und Einsatz

EN

4 - PRODUCT INSTALLATION

Before starting
procedure, ensure that the power
supply is disconnected.
Connect the spotlight male jack
to the female jack from the power
source; complete the jack coupling
by tightening the retaining cap.
Tighten the retaining springs, then
insert the spotlight into the previously
cut round hole. Push gently antil the
front element of the spotlight sits flat
on the mounting surface.

5 - MAINTENANCE

The spotlight does not require any periodic maintenance. The integrated
LED module in this lighting fixture is not replaceable. In case of failure,
proceed with the replacement of the entire spotlight. To remove it from the
installation site, pull it perpendicularly to the housing for about 2 cm.

6 - DISPOSAL

The packaging components (cardboard box and plastic bag) must be di-
sposed of in the appropriate bins. The device is considered an WEEE
(Waste Electrical and Electronic Equipment) and must be disposed of ac-
cording to the regulations in place at the installation location.
DO NOT DISPOSE OF IN THE ENVIRONMENT!
8
the installation
Fig. 5