Key Automation SPARK03 Anleitungen Und Hinweise Zu Installation Und Einsatz Seite 4

EN
WARNING !
The product must only be installed on metallic
surfaces. It is not suitable for direct installation on
flammable surfaces.
WARNING !
The product is not suitable for being covered with
thermally insulating material.
All installation, wiring, or maintenance operations must be carried
out with the power supply disconnected and under safe conditions.
Always comply with the declared power supply specifications. Observe the
indicated polarities. Use only SELV-equivalent power supplies with a
constant regulated output voltage of 24V. If the spotlight is integrated
into a larger system, ensure that its specifications are compatible with all
components involved, with particular attention to the characteristics outli-
ned in Chapter 1.2 (Technical Specifications) of this manual.
Incorrect connections may damage the devices and compromise the fun-
ctionality and safety of the system.
Perform all wiring connections in a manner that ensures the required pro-
tection level for the installation environment. If the connections are hou-
sed within the same compartment as the product installation, ensure an
IP protection level equal to or greater than that declared for the device.
The LED module integrated into this lighting fixture is not repla-
ceable. In the event of a malfunction, replace the entire spotlight.
Key Automation S.r.l reserves the right to modify these instructions if ne-
cessary. The updated version of these instructions and/or superior ver-
sions can be found on the website: www.keyautomation.com
4