Maintenance - Makita LB1200F Betriebsanleitung

• During transportation the saw band guard should be fully down
and close to the table.
• Do not use guarding for handling or transportation.
CAUTION:
• If handle is raised too high, the machine may topple over.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
NOTICE:
• Never use gasoline, benzine, thinner, alcohol or the like.
Discoloration, deformation or cracks may result.
Cleaning
Clean out sawdust and chips from time to time. Carefully clean the
blade guard and moving parts inside the band saw.
Lubrication
To keep the band saw in tip-top running condition, and to assure
maximum service life, oil or grease the moving parts and rotating
parts from time to time.
To reduce the emitted noise, always be sure that the blade is sharp
and clean.
To maintain product SAFETY and RELIABILITY, repairs, any other
maintenance or adjustment should be performed by Makita
Authorized Service Centers, always using Makita replacement
parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use
with your Makita tool specified in this manual. The use of any
other accessories or attachments might present a risk of injury to
persons. Only use accessory or attachment for its stated
purpose. If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Band saw stand
• Hex wrench
• Rip fence
• Miter gauge
• Circular cutting attachment
• Extension table
• Belt sanding attachment
For European countries only
Noise
The typical A-weighted noise levels are
sound pressure level: 81 dB (A)
sound power level: 94 dB (A)
Uncertainty (K): 3 dB (A)
Wear ear protection.
These values have been obtained according to EN61029.
EC Declaration of Conformity
We Makita Corporation as the responsible manufacturer
declare that the following Makita machine(s):
Designation of Machine: Band Saw
Model No./ Type: LB1200F
16
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following standards
or standardised documents:
EN61029
The EC-Type Examination Certificate No. M6A 10 05 26932 017
The EC-Type Examination was performed by:
TÜV SÜD Product Service GmbH, Zertifizierstelle,
Ridlerstaße 65, 80339 München, Germany
Identification No. 0123
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.,
Michigan, Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
Tomoyasu Kato
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, JAPAN
25. 05. 2010
Director