Voltage Setting; Quick Operation - Cyrusher Path Benutzerhandbuch

6.10 Voltage Setting

10P is the voltage setting option, the setting value is: 36V,
48V, 52V three kinds of voltage.
Short press [ ], enter the state of changing parameters,
short press [ ]/[ ] for parameter selection, short press
[ ], save the parameter setting and return to the
personalized parameter setting item selection interface;
6.11 Controller Auto Cruise Setting
11P is the controller auto cruise setting option, 0 means auto
cruise is not enabled, 1 means auto cruise is enabled.
Short press [ ], enter the state of changing parameters,
short press [ ]/[ ] for parameter selection, short press
[ ], save the parameter setting and return to the
personalized parameter setting item selection interface;
Fig.
6.10
Part7
7.1 Restore Factory Default Parameter
Setting Operation
If you forget the boot password, you can boot up the
computer by recovering the boot password. Recovering the
power-on password is as follows:
In the power-on password interface, press and hold [
and [
main interface will be changed from oP to dEF, then enter
the password 1212, short press [
interface, select dEF-y, long press [
enters the main interface, the power-on password has
been reset, the instrument does not need a password for
powering on the instrument, such as passwords can be set
up in the setup item for password setting.
Fig.
6.11

Quick Operation

] at the same time for more than 10 seconds, the
] to enter the option
], the instrument
Fig.
7-1
]
10