How To Use - Sharp Sj-Gp820C Bedienungsanleitung

How to use

• Wash the water tank and the ice storage box.
• Use ice tray cleaning mode to clean the ice tray
and the pipe. (There may be odor or dirt within the
automatic ice maker.)
Procedure
1
Pour water into
the water tank,
and set the
water tank.
3
1
Tank is full at this
position.
Note:
• Step 1 Do not use other than potable water. (juice,
tea, soda and sports drink etc.) They may dirty
the inside of the ice maker and lead to break
down.
• Step 2 Do not tilt the water tank. Otherwise, water
may spill when you carry it.
• Step 3 Insert the water tank securely. Ice cubes are
not be made unless the tank is inserted fully.
Ice cubes are made automatically.
2
Take out ice cubes.
• 2 types of ice cube are made at the same time.
Cube
• Ice cubes piled up at the back of the ice storage
box. Spread them out to the front part to make
more ice cubes.
How to assemble or disassemble water
tank
Latch
1
• The picture above shows how to assemble the tank.
Disassembly is in an opposite way.
EN-9
Warning
Fill with potable
water only.
Potable water
2
Multifaceted
shape
Latch
2
Water
tank
Note:
• It takes approximately 24 hours to make the first set of
ice cubes.
• For hygienic reasons, refill the water once a week even
if water remains in the tank.
• Remove the water tank approximately once a week
and wash it with water.
• When you leave the tank empty, it may sometimes
make a groaning noise but this is normal.
• Do not place the shovel or food on top of the ice
cubes. This may cause the automatic ice maker to
malfunction (damage of the detection lever, etc.) or the
case not being able to be pulled out. Set the shovel at
the designated location.
Shovel
• Large ice cubes may not be made when the water
level of the water tank is low even if "Large size" mode
is selected.
White in ice cubes and floating substance
• The minerals contained in water may solidify and
whiten as water freezes. Minerals turn into a state
which is insoluble once it freezes, so melting the ice
cubes will leave only white floating substance, but this
is normal.
• This is more likely to happen when you use hard water
(e.g. The hardness of the water is 100 mg/L or more).
Ice making takes longer when:
• The room temperature is high.
• Less cooling operation, e.g. in winter.
• Many food products are stored.
• Refrigerator is defrosting of the cooling unit.
• The door is frequently opened.
• When you restart the ice making operation.
• Energy saving mode is in operation.
Ice making right after changing the mode
• The batch of ice cubes made right after changing the
operating mode does not reflect the change in size.
This is because there are still half-made ice cubes left
in the ice tray when switching to the changed mode.
Ice cubes of the 2nd batch or later reflects the mode
change.
Protrusions of ice cubes :
There are some slits in the ice tray.
• Therefore, the ice cubes
have protrusions that
caused by these slits.
• The protrusions may bepointed.
Be careful when putting the
ice cube directly in your mouth.
Detection lever
Shovel
Slit
Ice tray
Protrusion