Identification Of Parts; Assembly Of The Lawn Mower - Texas A/S XT 1400 Gebrauchsanleitung

Identification of parts

1. Safety switch
2. Activation handle
3. Cable holder
4. Quick fix handles
5. Carry handle
6. Motor housing
7. Grass collector
8. Height adjustment
9. Mulching plug
(placed inside rear discharge)

Assembly of the lawn mower

Handle
Fit the lower part of handle to the lawn mower and fix it with the washers and brackets
(fig. A 1+2). The angle of the handle can be adjusted so it fits the user.
Fit the upper part of handle to the lower part using the washers, bolts and brackets (fig. B
1+2+3). There are 3 holes to choose from. This way the length of the handle can be
adjusted.
Be careful not to overtighten the brackets, as it might damage them !
They are supposed to be pressed down/locked with little effort.
If too tight, loosen the bracket by turn it one round and retry.
Grass collector
Click the rubber edge of the bag into the upper part of grass collector.
Push the metal frame into the upper plastic part (fig. C-1). Make sure that the lower metal
frame goes under the extended plastic part from bottom of bag.
Fix the metal frame into the sides and bottom of bag.
Use the 2 included screws and washers to fix the metal frame properly onto the upper
part of grass collector (fig. C-3).
In order to fit the grass collector on the lawn mower, first the mulching plug must be
1
4
5
6
11
3
7
9
8
2