Babboe Maxi-Cosi-Halterung Montageanleitung Seite 8

BABBOE CURVE
Preliminary remarks
Before starting installation, we advise you to check the packaging to ensure all parts are included.
The required parts are:
• One template (to drill the correct holes in the bottom panel).
• Sachet including:
- Two long bolts
 - Two lock nuts
 - Two metal rings (between lock nut and wood)
 - Two large metal washers
 - Two caps
The Maxi-Cosi carrier consists of two parts:
• Part 1: the base at the bottom of the box
• Part 2: the carrier for the Maxi-Cosi
Tools required:
• Drill and wood drill (6 mm diameter)
• Phillips screwdriver
• Open-end/ring spanner (size 10)
Installation
Step 1:
Preparations
The bench at the front of the box needs to be removed in order to use the Maxi-Cosi carrier. To do so, pull the
bench towards the handlebar and out of the guides. Ensure to give the latch at the bottom some room.
* The front of the cargo bike is shown in this manual as if it would be seen by you if you were sitting on
the saddle.
Step 2:
Placing the template
Unfold the supplied template; the template has the exact same width as the bottom panel. Cut the corners of the
template along the dotted line as indicated. Stick the template to the bottom of the box as indicated; the cut-outs in
the corners correspond to the cut-outs in the bottom panel.
14
Step 3:
Drilling the holes
Drill the holes in the indicated spots on the template.
Step 4:
Installing the base on the bottom
Place the bolts in the holes of the base. Put the metal
washers over the bolts. Then place the base on the
bottom panel in the holes (as shown in the picture).
Tighten the nuts using the open-end spanner and
screw driver.
Step 5:
Installing the carrier onto the base
Place the carrier onto the base by 'hooking' it behind the
front metal strip. Then tilt the carrier downward between
the two rear strips. Now turn the latching mechanism so
the carrier is firmly secured to the base. The carrier is now
ready to use.
Step 6:
Placing the Maxi-Cosi in the carrier
In order to correctly place the Maxi-Cosi in the carrier, the
carrying handle should be in the upright position. Secure
the two rubber bands on both sides of the carrier, with the
closed side of the hook facing inwards. Secure the hooks
on the front of the carrier to the lower "rods" (see A in the
picture on the right).
You are now ready to take your baby in the Maxi-Cosi
carrier in your Babboe cargo bike. Wishing you lots of
cargo bike fun!
Carrying handle in
the upright position!
Secure the rubber bands on both sides. Closed side of the
hook facing inwards. Front hook attached to lower rod!
15