Babboe Maxi-Cosi-Halterung Montageanleitung Seite 7

BABBOE CARVE
Preliminary remarks
There is no need to drill extra holes in the box in order to install the Maxi-Cosi carrier in the Babboe Carve,
you will be using the existing holes in the box.
The Maxi-Cosi carrier consists of two parts:
• Part 1: the base at the bottom of the box
• Part 2: the Maxi-Cosi carrier
Tools required:
• Open-end/ring spanner 10
• Allen key size 4
• From the supplied sachet you will need:
- the two large metal washers
Installation
Step 1:
Preparations
Unscrew the two bolts in the box with the Allen key and
open-end/ring spanner. Keep the nuts, bolts and metal
washers handy, you will be using them later on.
Step 2:
Installing the base on the bottom
Place the bolts in the inner holes of the base. Put the
metal washers over the bolts. Then place the base on
the bottom in the holes (as shown in this picture).
Put the washers and nuts back on the underside of the
box and tighten the bolts until the base is firmly fixed
in place.
12
Step 3:
Installing the carrier onto the base
Place the carrier onto the base by 'hooking' it behind
the front metal strip. Then tilt the carrier downward
between the two rear strips. Now turn the latching
mechanism so the carrier is firmly secured to the base.
The carrier is now ready to use.
Step 4:
Placing the Maxi-Cosi in the carrier
In order to correctly place the Maxi-Cosi in the carrier, the
carrying handle should be in the upright position. Secure
the two rubber bands on both sides of the carrier, with the
closed side of the hook facing inwards. Secure the hooks
on the front of the carrier to the lower "rods" (see A in the
picture on the right).
You are now ready to take your baby in the Maxi-Cosi
carrier in your Babboe cargo bike. Wishing you lots of
cargo bike fun!
Carrying handle in
the upright position!
Secure the rubber bands on both sides. Closed side of the
hook facing inwards. Front hook attached to lower rod!
13