Halemeier S-Mitter Basic MultiWhite2 Bedienungsanleitung Seite 4

S-Mitter Basic MultiWhite²
1-Channel Zigbee Transmitter
Programming the remote control with the receivers (TouchLink)
Press and hold buttons 1 and 2 simultaneously. Rapid flashing of
the indicator LED signals successful pairing.
The indicator LED flashes 6 times.
A light connected to the receiver begins to flash several times.
Release again and wait approx. 10 seconds.
The receiver can be controlled with the remote control.
Reset - Remove all connections to start a new configuration
If you encounter problems connecting, we recommend resetting the device. This will delete all connections to other devices and
to the network.
Resetting the remote control:
Press the on/off & 2 buttons for longer than 3 seconds.
The successful deletion of a connection is signalled by the
indicator LED flashing 3 times.
Then press any button again.
The remote control can now be re-learnt.
4 Halemeier GmbH - Lange Straße 51 - 49326 Melle Neuenkirchen -
cq
1x
hold
6x
10s
>3s
hold
3x
1x
www.halemeier.de
25.825.09 09. 10. 2025