Troubleshooting - Dogtrace D-Control/Mini Bedienungsanleitung

6. TROUBLESHOOTING

1. Read again this user guide and make sure the problem is not caused by a
flat battery or incorrect use.
2. Make sure the batteries are inserted with the correct polarity.
3. If the transmitter does not communicate with the receiver, try pairing the
devices again (chapter 5.4 Pairing the transmitter with the receiver).
4. If your dog seems unresponsive to stimulus:
Check again that the battery in the receiver is not low.
Test the functionality of the receiver using a test discharge lamp (see Section
5 of this chapter).
Check that you have selected the correct length of the contact points
(chapter 5.5 Selecting contact points) and that you have secured the contact
with the dog's skin by tightening the collar.
If the dog has dry skin, moisten it.
5. To check the correct function of the stimulation pulse, use the test discharge
lamp.
Make sure the receiver is switched off.
Place the test discharge lamp in contact with each of the contact points (as
shown in Figure 3 on page 3) - loosen the contact points, insert the lamp's
outlets under the contact points so they are in the touch with the screw and
tighten them.
Switch on the transmitter and receiver.
The test discharge lamp will increase a light intensity when increasing
stimulation level.
26