Checking The Battery Status; Switching The Collar On/Off - Dogtrace D-Control/Mini Bedienungsanleitung

TIP: The battery is easier to remove with a small screwdriver, which you
insert carefully under the battery edge.
5.2 Checking the status of the battery
To check the status of the battery in
the receiver, use the indicator light
(LED) on the side of the receiver
(Figure 1/3 on page 2).
If the battery is weak or completely
discharged, insert a new CR2 3V
lithium battery into the receiver.
5.3 Switching on/off collar
A magnetic switching system is used to switch the
receiver on or off (or to pair the transmitter with the
receiver), which is activated by applying a magnet. The
magnet is located at the bottom of the transmitter.
Switching on:
1. Place the bottom of the transmitter against the red
target/half round indicator on the receiver - the red
indicator light will come on, followed by the green
indicator light.
2. When the green light comes on, move the transmitter
away from the receiver. The green light will start
flashing.
Switching off:
When switching off, follow the same procedure as
when switching on the receiver.
EN EN
Battery status
100 % Green indicator light
Simultaneous green
35 %
and red indicator light
20 % Red indicator light
Receiver
d-control
d-control mini
23