Power Limitation - Franke Smart Fsm 7072 4Rc R Hi Benutzerhandbuch

Single cooking zone (R.180 mm) 1500 W, with
1
2000 W Booster function
Single cooking zone (R.180 mm) 1500 W, with
2
2000 W Booster function
Single cooking zone (R.180 mm) 1500 W, with
3
2000 W Booster function
Single cooking zone (R.180 mm) 1500 W, with
4
2000 W Booster function
5 Control panel
6 Extractor
Combinable cooking zone (R.180 x 360 mm)
1 + 2
3000 W

POWER LIMITATION

When connecting the appliance to the
household power supply for the first time, the
installer must set the power of the cooking
zones based on the actual capacity of the
household power supply.
If this is not necessary, the hob can be turned
on directly using or, alternatively, follow the
procedure described below to access the
menu.
• Connect the hob to the domestic mains
power (this operation must be performed
each time the menu is accessed).
• Switch on the hob using
• Press and hold " - " and " + " of the Timer area
( ) and until the initial setting is
displayed.
• The digit for the Timer area will show "Po".
• Press "-" or "+" of the Timer area (
change the power digit displayed in digits A
and B.
INDICATORS
Pan detection
If the pan is removed during operation or an
unsuitable pan is used, the symbol
on the display.
Residual heat indicator
The residual heat indicator is a safety feature,
indicating that the surface of the cooking area
is still at a temperature of 55°C or above, which
may cause burns if touched with bare hands.
The digit for the corresponding cooking area
indicates
• Press simultaneously to confirm the
See the following table for the specifications:
.
Once the correct value has been entered,
confirm by pressing and holding "-" and "+" of
the Timer area (
) to
Confirmation is given by the acoustic signal
and all LEDs light up.
9
Combinable cooking zone (R.180 x 360 mm)
3 +
4
3000 W
.
selection.
Value on the digits (KW)
7.4
6
5
4
3.5
3
2.5
appears
Notes
Standard initial
setting
), or wait 1 minute.
EN