Installation Requirements; Electrical Connections - Franke Smart Fsm 7072 4Rc R Hi Benutzerhandbuch

until it is closed.
The valve can be replaced and it can be
purchased as a spare part.
Cleaning the appliance
Clean the appliance after every use to prevent
any residual food from getting burned on it. It is

INSTALLATION REQUIREMENTS

The installation process must comply with the
laws, ordinances, directives and standards
(electrical safety rules and regulations, proper
recycling in accordance with the regulations,
etc.) in force in the country of use!
• Do not use silicon sealant between the
appliance and the worktop. The cooker hob
is designed to be fitted flush with the kitchen
worktop, on a kitchen unit with a width of
600 mm or more.
• If the appliance is installed on flammable
materials, the guidelines and regulations
relating to low voltage installations and fire
prevention must be followed strictly.
• For built-in units, the components (plastic
materials and veneered wood) must be
mounted with heat-resistant adhesives
(min.100°C): the use of unsuitable materials
and adhesives can cause deformation and
detachment.
• The kitchen unit must have sufficient space
to allow for electrical connection of the

ELECTRICAL CONNECTIONS

much harder work to remove encrusted and
burnt-on dirt.
• For day-to-day dirt, use a soft cloth
or sponge and a suitable detergent. Follow
the manufacturer's recommendations
regarding detergents to be used. The use of
protective detergents is recommended.
• Remove encrusted dirt, for example milk
that has boiled over, using a scraper pad
suitable for vitreous ceramic, while the hob
is still hot. Follow the manufacturer's
recommendations regarding scraper pads
to be used.
• Remove any melted plastic using a scraper
pad suitable for vitreous ceramic, while the
cooker hob is still hot. If you do not, the
residue may damage the vitreous ceramic
surface.
• Remove limescale using a small amount of
limescale remover solution, for example
vinegar or lemon juice, once the cooker hob
has cooled down. Then, clean again with a
damp cloth.
device. Wall-mounted units above the
device must be installed at a sufficient
distance to leave the space required to work
in comfort.
• The use of decorative hardwood borders
around the worktop behind the device is
allowed, provided the minimum distance
always complies with the indications
provided in the installation drawings.
• The minimum distance between the fitted
device and the rear wall is indicated in the
installation drawing for the flush-fitted
device (150 mm for the side wall, 40 mm for
the rear wall and 500 mm for any wall-
mounted units above it. For ergonomic
reasons a minimum distance of 1000 mm is
recommended).
• To prevent infiltration of liquids between the
edge of the cooker hob and the worktop, fit
the adhesive seal supplied along the whole
outer edge of the cooker hob prior to
installation.
WARNING: All electrical connections
must be carried out by an authorised
installer.
• Follow the connection diagram (underneath
the product).
7
EN